|
|
 printable version
Access, protection
Keys and locks - the general information
1. The standard car is mandatory includes two sets of keys - primary and secondary. The master key is used to unlock all locks on the vehicle, does not fit extra locks to the glovebox and luggage compartment are usually transferred employee service center, where the car is stripped for repair or maintenance.
2. The scope of the keys attached label with the serial ID number that should be removed to a safe place and keep out of the car. According to the available information on the label in the representation of Nissan's always possible to order a new set of keys in case of their loss.
 | It would be wise to rewrite the information number from the label notebook. |
 | 3. If the vehicle is equipped with a proprietary anti-theft system Nissan NATS V2.0 with engine immobilizer, to him will only fit specific corporate key NATS, which is also assigned identification number. Any new key is to undergo the procedure of alignment with the anti-theft device NATS, - refer to the branded service stations Nissan. During the procedure of combination of memory erases all data previously stored there. |
 | 4. To lock the door key insert it into the lock located on the wall outside handle and rotate counter-clockwise (unlocked by turning the key in the opposite direction). At the same time locking the driver's door is locked all the car doors. |
 | 5. If the ignition key left in the lock to lock the driver's door from the outside is not possible. In order to lock without a key outside the passenger door turn the lock lever to the "Locked" and slam the door. |
Additional locking rear door locks
1. Lock prevents accidental opening of the rear door, which is especially important when there are children in the car young children.
 | 2. When a translation to the LOCK lever lock the back door can only be opened from outside the vehicle. |
A single electric lock
general information
 | A single electric lock makes it possible to simultaneously lock or unlock all the door locks using a button located on the remote control the driver's door or by locking / unlocking the driver's door key from the outside. |
 | The control panel on the driver's door armrest mounted main switch of a single lock, with which you can also lock all the doors except the driver. |
Remote control of a single electric lock
 | 1. The system of a single electric lock allows remote locking and unlocking of the door locks, including locking the luggage compartment lid, and turn on / off interior lights. Remote Control (RC) is in the form of a key fob, which clings to the master key of the car. |
2. Failures triggering the remote control can be caused by:
a) The key is in the ignition;
b) fell the charge level of the battery panel;
c) The distance between the remote control and the vehicle is greater than 1 m.
Locking
1. Remove the key from the ignition, the doors slam.
2. Press the door lock button on the remote control. Serviceability locking doors is confirmed visually by the warning light anti-theft system. Do not be amiss to make sure to check the reliability of locking the door manually.
Unlocking
1. Press the door release button on the remote control - should work activators of locks.
2. If the interior light switch in the middle position, the cabin for 30 seconds, the interior lighting.
3. If within 30 seconds after unlocking the door of any one of them will not be disclosed or not pressed any button on the remote will automatically lock all doors.
4. The interior lights can be turned off without waiting for the specified period of time (30 seconds). To do this, insert the key into the ignition and turn it to ON, the locked doors or using the remote control. You can also use the switch interior lights.
Unlocking the luggage compartment lid
1. Press the luggage compartment lid unlocking on the remote control - should occur triggering the appropriate activator. | Do not hold the button down for longer than one second. |
2. Cover the luggage compartment can be opened using the remote control, if the lever lock its lock switch is set to "CANCEL". In this case, use the key.
Interior lighting control
Press the corresponding button on the remote control. If the interior light switch is set to the middle position "0", the interior lights will turn on for 30 seconds. You can turn off the lighting force without waiting for a specified time period.
Replacing the battery
 | Disposal of used batteries must be in accordance with the requirements set by local authorities in order to avoid harming the environment. |
1. The power supply remote control uses a lithium battery type SR2025. Try not to control moisture, make sure that in the process of replacing the inside of the console has not got oil.
 | 2. Turning with a suitable tool (or coins), open the round cover on the rear of the console. |
3. Remove the old battery panel and replace it with a new one.
4. Replace and tighten the cap.
5. To check the serviceability of functioning of the remote repeatedly click on any of its buttons.
Access to the engine compartment
 | 1. Handle the lever releasing the bonnet located to the left under the dashboard of the car. When the handle is pulled over the hood should be slightly raised.
2. When you release the latch bolt exit from the salon and go around the car in front. Optional locking latches lock lever located under the front edge of the bonnet. |
3. Before you slam the hood, make sure that it is not left in the engine compartment no tools, rags, and other obstructions. Track reliability of fixing the hood latch.
Access to the glove compartment
 | 1. Unlocking / locking glove box can be made only by means of the main key. To open the box lid should pull over the handle of his castle, snap lock automatically when you close the cover. Opening the box when the ignition is accompanied by automatic inclusion of its illumination. | Cover is not closed glove compartment when a traffic accident can cause serious injury to the passenger sitting in the front seat, even if he is wearing a seat belt! |
|
Access to the luggage compartment
Unlocking the salon
Version A
 | Lever release cap located on the outside of the driver's seat. To open the luggage compartment, pull the lever up. Locking takes place automatically when the collapse of the cover. |
Version B
Cover release button is located under the armrest of the driver's door. To open the luggage compartment, press the switch. Locking takes place automatically when the collapse of the cover.
Unlocking with the key
 | 1. To open the luggage compartment lid, turn the key in the lock it clockwise. Latching lock automatically when the collapse of the cover. |
 | 2. Lock the luggage compartment lid is equipped with special blocker. When translating the handle lock position "CANCEL" unlocking the cover is only possible using the key. |
Access to fuel filler
Unlocking
Version A
 | To unlock the hatch filler should shift to the left of the driver's seat to the handle DP car and squeeze it down. Latching lock automatically when you close the cover. |
Version B
To unlock the cover, press the control. Latching lock automatically when you close the cover.
Removing cork
| As a replacement, use only original plugs manufactured by Nissan. Inside plug built safety valve, providing serviceability of functioning of power systems and engine management |
 | 1. The fuel filler vehicle equipped with right-hand thread is closed and ratchet stopper cork. |
 | 2. Remove the plug and secure it with the special bracket on the back cover flap. |
Ignition switch / steering lock
 | The ignition switch is located to the right on the steering column. The key in the lock can take one of four positions:
a) LOCK - Lock
b) ACC - auxiliary power consumers (parking position)
c) ON - ignition switched on
d) START - engine start |
The position "LOCK" - lock
1. The key can be inserted into or removed from the lock only in a given position. When you turn the ignition key from the "LOCK" position to the "ACC" position occurs unlock the steering column. To turn the key from the "ACC" position to the "LOCK", you must first click on it slightly, slightly sinking in the castle. In addition, on models equipped with automatic transmission, the key before removing the gear selector lever must be in position "P". Note: Opening the driver's door when parked in the castle, turn in the "LOCK" key triggers the alarm buzzer.
2. Lock the steering column is carried out automatically when you try to turn the steering wheel after removing the key from the ignition.
3. Lock the steering column sometimes causes inability to turn the key in the ignition. In such a situation lightly pull the steering wheel in both directions (for the purpose of removal of the load), while turning the key in the lock.
| In no case do not remove the key from the ignition while driving! This will inevitably lead to the blocking of the steering column, and a loss of control over the management. Remove the key from the lock until the vehicle is stopped. |
The position "ACC" - Webasto
In this position, the ignition key it is possible to support the functioning of electricity consumers (radio, cigarette lighter, the heater fan, windscreen wipers, etc.). | Opening the driver's door when parked in the castle, turned to the "ACC" key triggers the alarm buzzer. |
Position "ON" - the ignition is switched
1. In this position, the ignition switch is on while the vehicle is moving and when the engine is idling. At the same time it provides electrical power to all systems and is installed on the car accessories. When you turn the key from the "ACC" to "ON" position briefly included some located on the vehicle dashboard warning lights, confirming serviceability of functioning of the relevant control systems.
2. On some models, when you turn the key in the "ON" position automatically switched headlights (running lights daytime [DRL]).
The position "START" - start
When the key is in position, the starter switch. After the engine starts, release the key and it will automatically return to "ON".
|
|
