add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Maxima QX (1993 release)

general info. full specifications. diagnostics. hints. tips. tricks
Nissan Maxima QX
Home
 
Nissan
Maxima QX
Introduction
Operating Instructions
Adjustment and routine maintenance
Engine
System of cooling, heating
The power supply system and release
general information
Dropping the pressure in the supply system
Check of serviceability of functioning of the fuel pump, the fuel pressure measurement
Check and replacement of fuel lines and compression fittings
Removal and installation of the fuel pump
Check and replacement of the gauge of fuel consumption
Removing and installing fuel tank
Cleaning and repair of the fuel tank - an overview
Removal and installation of assemblage of an air cleaner
Removal, installation and adjustment of a cable of an accelerator
The electronic fuel injection (EFI) - General Information
Check of serviceability of functioning of system of injection
Check and replace the throttle body
Removal and installation of the fuel pressure regulator
Removal and installation of a fuel highway and injectors injection
Check and adjustment of turns of idling
Exhaust system - general information
Electric motor
Engine Control Systems
Transmission
Coupling and power shafts
Brakes
Suspension and steering
Body
Onboard electric
 


Hit Counter by Digits


print page printable version

The power supply system and release



Specifications

Common parameters

Type of power supply system Distributed injection
Idling speed (min - 1)
Models 1993 and 1994 Vol. 700
Models 1995 Vol.
With Manual transmission 550 ÷ 650
With AT 600 ÷ 700
Models with 996 MY.
With Manual transmission 525 ÷ 625
With AT With AT
Fuel pressure, kgf / cm2
Ignition ON, Engine OFF thirty
At idle 2.4 ÷ 2.5
The resistive impedance injectors Injection Ohm 10 ÷ 14
The resistance of the sensor of fuel consumption, Ohm
Models 1993 and 1994 Vol.
Empty tank 929 ÷ 1009
Polbaka 178 ÷ 195
Full tank 15 ÷ 18
Models from 1995 MY.
Empty tank 80 ÷ 83
Polbaka 32 ÷ 35
Full tank 5 ÷ 8
Efforts of a tightening of carving connections Nm
Tighten the screws on the covers injectors injection 2.5 ÷ 3.2
Bolts fuel line
Models 1993 and 1994 Vol. 24 ÷ 27
Models from 1995 MY. 16 ÷ 20
Bolts throttle body
Step 1 9 ÷ 11
Step 2 18 ÷ 22




« previos page
Removing and installing condenser K / V
next page »
general information

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.