add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Maxima QX (1993 release)

general info. full specifications. diagnostics. hints. tips. tricks
Nissan Maxima QX
Home
 
Nissan
Maxima QX
Introduction
Operating Instructions
Adjustment and routine maintenance
Engine
System of cooling, heating
The power supply system and release
Electric motor
General information and precautions
Starting the engine from the auxiliary power supply
Check and replace batteries
Check and replacement of wires of the battery
Ignition System - general information and precautions
Check the functioning of the ignition system
Check and replace the ignition coils
Check and replacement of the power transistor (models 1993 and 1994 issue.)
Check, adjustment, removal and installation of the distributor of ignition (models 1993 and 1994 issue.)
Check and adjust the ignition timing settings
Charge system - the general information and precautions
Checking the status of the charge
Removing and installing the generator
Start system - the general information and precautions
Check of serviceability of functioning of a starter and start chain
Removing and installing starter
Replacement of the traction relay
Engine Control Systems
Transmission
Coupling and power shafts
Brakes
Suspension and steering
Body
Onboard electric
 


Hit Counter by Digits


print page printable version

Electric motor



Specifications

Common parameters

Ignition system
Type Direct, electronically controlled
Battery voltage, V
When the engine is stopped 12
With the engine running 14 ÷ 15
Ignition order 1-2-3-4-5-6
Resistor ignition coil resistance at 20 ?� C (models 1993 and 1994 vol.), Ohm
Primary winding 10
Secondary winding 8000 ÷ 12000
Ignition timing 13 ÷ 17 ?� before TDC
Resistor resistance candle wires kW / dm 1.7 ÷ 3.0 (maximum 8.3)
Generator
Type
Model
In 1993 and 1994 Vol. LR190-709V, produced by Hitachi
Models from 1995 MY. LR1125-702V, LR1110-705 or LR1100-703, manufactured by Hitach
Nominal voltage, current, BA
LR190-709V 12-90
LR1125-702V 12-125
LR1110-705 12-110
LR1100-703 12-100
The polarity of the earth (all types) Negative
Minimum operating output current, A
LR190-709V
At 1300 rev / min 23
At 2500 rev / min 63
At 5000 rev / min 84
LR1125-702V
At 1300 rev / min 36
At 2500 rev / min 94
At 5000 rev / min 123
LR1110-705
At 1300 rev / min 34
At 2500 rev / min 82
At 5000 rev / min 205
LR1100-703
At 1300 rev / min 34
At 2500 rev / min 80
At 5000 rev / min 91
The minimum allowable speed with no load, rev / min (13.5)
LR190-709V Less than 950
LR1125-702V Less than 1100
LR1110-705 Less than 1000
LR1100-703 Less than 1000
Adjustable output voltage (all types), B 14.1 ÷ 14.7
The minimum allowable length of the brush, mm
LR190-709V 7.0
LR1125-702V, LR1110-705 and LR1100-703 6.0
The force of the brush springs H
LR190-709V 1.078 ÷ 2.548
LR1125-702V, LR1110-705 and LR1100-703 1.000 ÷ 3.432
The outer diameter of contact ring, mm
LR190-709V 30.6
LR1125-702V, LR1110-705 and LR1100-703 Over 26.0
The resistance of the rotor winding (LR1125-702V, LR1110-705 and LR1100-703), Ohm
LR1125-702V 2.35
LR1110-705 and LR1100-703 2.31
Starter
Type
Models 1993 and 1994 Vol. S114-461
Models from 1995 MY. S114-801A
The supply voltage (all types), B 12
Terminal voltage without load (all types), B eleven
Current (no load), A
S114-461 Less than 100
S114-801A Less than 90
Rotation (no load) / min
S114-461 More than 3000
S114-801A Over 2,700
The minimum diameter of the switch, mm
S114-461 32
S114-801A 28
Minimum length of the brush, mm
S114-461 12.0
S114-801A 10.5
The force of the brush springs H
S114-461 17.7 ÷ 21.6
S114-801A 12.7 ÷ 17.7
The difference in adjustment gear assembly, mm
S114-461 0.05 ÷ 0.8
S114-801A 0.3 ÷ 2.5




« previos page
Exhaust system - general information
next page »
General information and precautions

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.