add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Patrol (from 1988 to 1997, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Nissan Patrol
Home
 
Nissan
Patrol
Introduction
Troubleshooting
Adjustment and routine maintenance
Engine
System of cooling, heating and air conditioning
The power supply system and exhaust
Systems for reducing emissions
Systems of an electric motor
Transmission
Clutch
Brakes
The front and rear axles, chassis and steering
Body
Care body
Removing stains of different origin with vinyl upholstery and trim panels
Care of an upholstery and rugs salon
Repair minor damage to body panels
Repair of considerable damages of a body
Replacing the windscreen and of fixed glass panes
Service of the front door
Maintenance rear doors
Removing and installing bonnet
Service tailgate models of Hardtop (Hardtop) and Universal (Station Wagon)
Service tailgate models of utilities (Van) (Utility)
Removing and installing radiator grille
Removing and installing center console
Removal and installation of the front seats
Removing and installing rear seat
Service seatbelts
Removal and installation of the instrument panel
Onboard electric
 


Hit Counter by Digits


print page printable version

Removing and installing bonnet



Withdrawal

PERFORMANCE ORDER

  1. Lift the hood and secure it with emphasis.
  2. Cover the mud flaps of both wings with special lids or just old blankets to protect the paintwork. Pay particular attention to the protection placed at angles hood areas.
  1. Disconnect the fluid hose from the washing of a windscreen hose on the hood (see. Accompanying illustration).
  1. Marker plate circle loops, marking their location on the hood.
  2. Give bolts of fastening plates to the hood hinges, remove the washer. With the help of an assistant, remove the hood of a car.

Setting

PERFORMANCE ORDER

  1. With the help of an assistant install the hood on the car, fixing it in front of emphasis.
  2. Screw bolts to the hood hinge plates (do not forget to install the washers under their heads). Align the hinge in accordance with applied during the dismantling of the landing labels, only then can tighten the screws.
  3. Ask the assistant to hold the hood latch in the open position drive cable, do close the hood.
  4. Check the location of the lateral edges of the hood with respect to the wings of the car and the rear edge with respect to the body panel.
  5. If necessary, loosen the adjustment bolts to the hood hinges and properly tweak the position of the hood.
  6. Check the operation of the bonnet. When you release the lock the hood should be slightly lifted abruptly, allowing the fingers to reach the latch lock.
  7. To adjust, loosen the lock screws (see. Accompanying illustration) and slide the lock in the required direction. Tighten the screws.
1 - Castle
2 - bolts




« previos page
Maintenance rear doors
next page »
Service tailgate models of Hardtop (Hardtop) and Universal (Station Wagon)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.