REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Sunny (from 1991 to 1997, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Sunny
		Instructions
		Maintenance
		Engines
		Cooling
		Heating and ventilation system
		Fuel and exhaust system
			Carbureted engines
			Engines with fuel injection system
			The power supply / exhaust
				Models with one-point electronic fuel injection
				Models with multi-point electronic fuel injection
					Specifications
					Air filter
					An accelerator rope
					The accelerator pedal
					Fuel Injection System
					Fuel system
					Fuel pump
					Fuel Level Sensor
					Fuel tank
					Throttle Body
					Elements of the fuel injection system (engines of 1.6 liters)
					Elements of the fuel injection system (engines of 2.0 liters)
						The fuel manifold and fuel injectors
						Fuel pressure control
						Throttle potentiometer
						Air Flow Sensor
						Additional air valve
						The solenoid valve of the engine fast
						Adjusting the air supply unit (idle)
						Air intake control valve
						Sensor crankshaft angle
						Power Transistor
						The gauge of detonation combustion of fuel
						The electronic control unit of engine work
						The switch of neutral transfer
						The switch of blocking of a starter / reversing light
						Switch the engine-ECU and fuel pump
						The switch in the steering gain
						Switch the air conditioning system
						Speed sensor
					Intake manifold
			Emission of exhaust gases
		The system of the engine is started
		Coupling
		Transmissions
		Axles
		Brakes
		Suspension and steering
		Body
		Electrical

printable version

Adjusting the air supply unit (idle)

Adjusting the air supply unit when the engine is idling mounted on the right side of the intake manifold.

Before his removal, disconnect the negative battery terminal.

Refitting

PERFORMANCE ORDER

1. Disconnect the connection of the additional control valve and air solenoid valve quick work of the engine idling and remove the wires from the mounting clamps.

2. Turn off fixing bolts and remove the block from the intake manifold. Peel off the pad and throw it away; When installing, use a new one.

3. When installing, make sure that the contact surfaces of the block and intake manifold are clean and dry, then install the new gasket. Install the nut adjusting the air supply, and tighten the mounting bolts. Plug connectors and connection wire of the negative battery terminal.

« previos page
The solenoid valve of the engine fast

next page »
Air intake control valve