printable version
Parking brake lever
Removal in the following order:
| Fig. 12.28. Parking brake: 1 - the lever; 2 - lever handle; 3 - the top decorative overlay of the lever; 4 - the switch of a control lamp; 5 - draft; 6 - compensator 7 - carving tip of a cable; 8 - the parking brake cables; 9 - Protective sleeve
|
- Press the knob locks, located at the bottom rear of the handle and pull, remove the handle 2 (Fig. 12.28) hand brake lever 1; - Remove the top decorative overlay of the lever 3; - Remove the rear of the center console; - Unscrewing the lock nuts and adjusting nuts, remove them from the threaded end of the cable 8 parking brake; - Unscrew the two screws securing the lever to the floor and remove the lever 1 with the compensator 6. If necessary, turn the compensator to thrust lever by 90 ?� and remove it. Installation spend to sequences, return to removal. Adjust the parking brake cables, and then set the rear of the center console and the trim lever.
|