printable version
Replacing the brake disk peredneo
Check technical condition of front brake disc spend in the following order: hang out the front of the car and fix on the support post. Remove a corresponding forward wheel; diagonal screw without tightening the two screws on the wheel. Clean the disc from corrosion and check for wear and defects; using a micrometer, check the thickness of the disc; using a dial gauge, check the runout of the brake disc. It is checked at a distance of 10 mm from the outer edge of the disc.
| Fig. 12.10. Rear brake drum: 1 - the working brake cylinder; 2 - a brake board; 3 - the bolt of the brake cylinder; 4 - retaining pin; 5 - plug inspection hole; 6 - brake shoes; 7 - cup; 8 - compression spring; 9 - the lower the return spring; 10 - tension spring wedge; 11 - wedge; 12 - Spreader bracket; 13 - the upper return spring; 14 - pressure spring; 15 - the lever of a manual brake
|
Removing the front brake disc procedure is as follows (Fig. 12.10): Remove the caliper holder without disconnecting the brake hose; using wire, hang the caliper to the front of the rack; Unscrew the wheel bolts, which were installed at the check disk; Unscrew the screw securing the brake disc to the hub and remove the drive. The installation of front brake disc spend to sequences, return to removal.
|