add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Passat B6
Home
 
Volkswagen
Passat B6
Operation and maintenance of car
Engine
Overview
Mechanical (engine capacity of 1.6 liters)
Removal and installation of the top casing of the engine
Check the timing belt (4-cyl. Petrol engines of 1.6 liters)
Removing Engine
Engine installation
Disassembly and assembly of the engine
Removing and installing V-ribbed belt
Removing and installing timing cover
Replacing crankshaft oil seal on the side of the pulley
A method of tightening the mounting bolt sprocket belt drive
Dismantling and assemblage of pistons and rods
Cylinder Head
Checking the valve timing
The timing
Removing and installing the camshaft housing
Removal and installation of the cylinder head
Compression Test
Repair the valve mechanism
Checking the valve guides
Replacing valve stem seals
Lubrication system
Cooling system
Fuel Injection System
The mechanical part (petrol engines of 2.0 liters)
Lubrication system
System ohlazhdeiya
Fuel system
Injection system
System of release of gases otrabotavschih
Ignition system
The mechanical part (diesel engines of 2.0 liters)
Lubrication system
Cooling system
Fuel system
Turbocharging turbo running on exhaust
The direct injection diesel
Exhaust
Tables
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Engine installation



Installation is carried out in reverse order.

ATTENTION
When all installation work, in particular in the engine compartment, because of the tight layout, consider the following.
Lines of all types (e.g. fuel, hydraulic absorber, activated carbon, cooling systems, coolant, brake lines, vacuum tubes), and also necessary to lay electric wires as they were originally laid.
Provide sufficient space to all moving or hot components to avoid damage to any kind of lines.

Vehicles with manual transmission
Check clutch release bearing for wear and replace if necessary.
Lightly grease clutch release bearing, guide bushing and the teeth of the input shaft with grease.
Check the engine block-fitting sleeves for centering the engine / gearbox, if necessary, install them.

The intermediate plate
Fig. 2.11. The intermediate plate


Suspend the intermediate plate on the flange and put it on the sleeve-fitting (Fig. 2.11).
When the unit is installed must have sufficient space to pivot shafts.
Align the engine mount, shaking him.
Install drive shafts.
Install the air conditioning compressor.
Install poly V-belt.
Install hydraulic clutch slave cylinder.
Connect the drive gear.
Install the battery and battery holder frame.
Connect the battery.
Install the front left and right wheel arch liner.
Install the crankcase.
Fill in cooling liquid.
Install the air filter.
Remove the value in memory and adapt engine control unit to the control module and the throttle valve EGR.

Tightening torques




« previos page
Removing Engine
next page »
Disassembly and assembly of the engine

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.