add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Touareg (from 2003 to 2006, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Touareg
Home
 
Volkswagen
Touareg
Operation and maintenance of car
Engine
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
Exterior body parts
Removing and installing bonnet
Removing the gas stop
Release of gas from the gas stop
Removing and installing insulation
Removing and installing bonnet
Adjust the bonnet
Disconnecting the flexible cable
Removing and installing tailgate
Adjusting the tailgate with the hinge
Adjusting lock loop
Removal and installation of a gas cap lock
Removal and installation of a gas cap lock
Removal and installation of elements of the locking and unlocking doors
Removing and installing lock the tailgate
Removing and installing lock loop soft closing
Removal and installation of the motor opening the tailgate
Removing and installing rear spoiler
Removal and installation of elements of the locking and unlocking the fuel filler flap
Adjusting the door
Removal and installation of the lock cylinder housing
Removal and installation of door handles
Removing and installing door lock
Adjusting the back door
Removal and installation of the lock cylinder housing
Lifting sunroof with glass panel
Removing the glass panel lifting and sliding sunroof
Check the parallel progress of the glass panel
Fit seal the hatch panel
Removing sunglass
Removal and installation of facing of the front bumper
Removing and installing rear bumper fascia
diagrams
 


Hit Counter by Digits


print page printable version

Release of gas from the gas stop



Gas compression zone stops
Fig. 8.3. Gas compression zone stops


Pinch gas stops in the area of X = 50 mm in the grip (Fig. 8.3).

ATTENTION
Clamping gas stops in the grip is allowed only in the area of X, otherwise there is a risk of damaging stress and injury.

Separate the gas cylinder all the way into the first third of the entire length of the cylinder, starting from the edge on the side of the stem.

NOTE
During cutting, always wear safety glasses.

Cover the area with a cloth cutting.
Dispose of the oil and rags under the current rules.




« previos page
Removing the gas stop
next page »
Removing and installing insulation

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.