1. Jack up the rear of the car and establish it on reliable support. |
2. Remove the wheels. |
3. Removal spend in the sequence shown in the figure. |
4. Check the condition of all details and, if necessary, repair or replace them. |
5. Installation spend to sequences, return to removal, taking into account the following. |
6. Install the wheel.
Torque: 88-118 N ??? m |
7. Install the rear crossmember, measure the wheel alignment parameters and, if necessary, adjust it. |
A warning Secure the bracket and tightening the bolt stabilizer lateral thrust is not to end, lower the car and tighten all bolts and nuts the demanded moments in not loaded condition.
|