1. Jack up the rear of the car and establish it on reliable support. |
2. Remove the wheels. |
3. Removal spend in the sequence shown in the figure. |
| 4. Before loosening the nuts mating marks on the plate, cover and cross-beam. |
| 5. Move the jack under the crossmember, and then remove the nuts. |
A warning Do not drop the cross.
|
6. Check the condition of all details and, if necessary, repair or replace them. |
7. Installation spend to sequences, return shown on drawing, taking into account the following. |
| 8. Install the cover plate, so that it is oriented in the same direction as the cutout on the adjusting bolt to the plate and the deck plate. Torque: 86-117 N ??? m |
9. Install the wheel. Torque: 88-118 N ??? m |
A warning Tightening the fastening bolts and nuts transverse to the longitudinal rods and rod not fully, lower the car and definitively tighten all bolts and nuts the demanded moments in not loaded condition.
|
10. Install transverse and longitudinal rods, measure the wheel alignment parameters and, if necessary, make adjustments. |