1. Jack up the front part of the car and establish it on reliable support. |
2. Remove the wheel and the bottom cover. |
3. Remove the constituent elements in the sequence shown in the figure, taking into account the following. |
| 4. Remove the engine mounting plate, after fixing the engine a special device. |
5. Bring under the stabilizer support, and then remove the bolts and nuts. |
6. Remove the stabilizer bracket. |
| 7. Slowly lower crossmember, and then remove the stabilizer bar from the crossmember. |
8. Check the condition of all details and, if necessary, repair or replace them. |
9. Installation spend to sequences, return shown on drawing, taking into account the following. |
10. Apply grease to the inner surface of the rubber sleeve stabilizer. |
| 11. Establish the plug on the marks on the stabilizer bar. |
| 12. Install the bracket in the direction shown in the figure.
Torque: 43-61 N ??? m |
A warning Do not change the direction of the installation.
|
13. Install the wheel. Torque: 88-118 N ??? m |
A warning Tightening the shock absorber mounting bolt and the lower arm is not fully, lower the car and definitively tighten all bolts and nuts the demanded moments (unloaded).
|
14. Make the adjustment of the front wheels. |
15. Remove air from a hydraulic drive power steering. |