1. Jack up the rear of the car and establish it on reliable support. |
2. Remove the wheels. |
3. Removal spend in the sequence shown in the figure. |
4. Check the condition of all details and, if necessary, repair or replace them. |
5. Installation is spent to sequences, return to removal, taking into account the following. |
6. Coat the inside of the sleeve stabilizer grease for rubber. |
| 7. Install the sleeve marks on the stabilizer bar. |
8. Install the wheel. Torque: 88-118 N ??? m |
A warning Tightening the bolts of the stabilizer is not until the end, lower the car and definitively tighten all bolts and nuts the demanded moments in not loaded condition.
|