| 1. Jack up the front part of the car and establish it on reliable support. |
| 2. Remove the wheel and the bottom cover. |
| 3. Remove the constituent elements in the sequence shown in the figure, taking into account the following. |
| 4. Cut the rubber bushing from the front lower arm. |
 | 5. The special adaptation clamp the lower arm and remove the plug. |
 | 6. Check the condition of all details and, if necessary, repair or replace them.
Lower arm - for damage and cracks. |
The sleeve - for deformation and wear.
Dust cap - for damage.
Ball joint - for wear and damage. |
A warning  When replacing the ball joint, and replace the lower arm assembly.
|
 | 7. Attach the ball joint of the lower arm and a special device to measure the load with a spring balance. |
A warning Several times shake a finger of the spherical hinge and measure the load. The load on the ball joint: 0,98-4,9 N ??? m
|
| 8. Installation spend to sequences, return shown on drawing, taking into account the following. |
 | 9. Install the new hub of the lower arm, and then a special device, enter it in the lower arm. |
10. Install the wheel.
Torque: 88-118 N ??? m |
A warning Tighten the bolts of the lower arm is not fully, lower the car and definitively tighten all bolts and nuts the demanded moments (unloaded).
|
