1. Lift the car and fix on support. |
A warning The liquid in the tank popolnitelnom brake system should be maintained at 3/4 or higher in the course of pumping.
During air removal add only the pure liquid recommended by the manufacturer
|
2. Remove the cap from the bleeder, and connect to it a hose. |
3. Place the other end of the hose in a glass container of sufficient volume. |
4. The assistant should slowly press the brake pedal a few times, then hold it down. |
| 5. When the brake pedal depressed key OK130 430 019, loosen the bleeder valve and release the air from the hydraulic system. |
6. Tighten the bleeder valve and release the brake pedal. Torque: 5,9-8,8 N ??? m |
A warning Both people must be able to talk to each other. In the open socket is not allowed to release the brake pedal.
|
7. Repeat steps 4-6 until the until the brake liquid without air bubbles. |
8. Screw the cap on the bleeder valve. |
9. Check the correct operation of the brakes. |
10. Check for leaks of brake fluid. |
11. Fill the brake fluid in the reservoir popolnitelny brake system. |
A warning Air flow should be performed starting from the union, the most remote from the brake master cylinder.
|