printable version
The main brake cylinder
The main brake cylinder and brake servo 1 - Connector brake fluid level; 2 - the brake pipe; 3 - a nut; | 4 - a tank; 5 - O-ring; 6 - the brake servo. | Refitting A warning The brake liquid dissolves a paint, plastic and wire insulation, so if you accidentally hit fluid on the paintwork of the car or its components wash with plenty of water.
PERFORMANCE ORDER | 1. Disconnect the negative battery terminal. | 2. Disconnect the connector from the brake fluid level. | 3. Disconnect the brake pipes from the brake master cylinder and close their plastic stoppers for a hit exception in them a dirt. | 4. Remove the two nuts securing the master cylinder. | 5. Remove the brake master cylinder. |
| Check
Setting
PERFORMANCE ORDER | 1. When installing a new brake master cylinder pushrod adjust the position of the brake servo. | 2. Install the brake master cylinder to the brake servo and screw the two nuts. | 3. Tighten the two nuts securing the master cylinder. The inhaling moment: 9,8-15,7 N ??? m | 4. Connect the two tubes of brake system. | 5. Tighten the nuts tubes of brake system. The inhaling moment: 1,8-21,6 N ??? m | 6. Connect to the brake fluid level. | 7. Top up the brake fluid and bleed the hydraulic circuit brake system. | 8. Attach the wire to the negative terminal of the battery. |
|
|