add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Magentis / Optima (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks
Kia Magentis
Home
 
Kia
Magentis
Engines
Lubrication System
Cooling system
The control and toxicity
Fuel system
Ignition system
Coupling
Transmission
Power shafts, axles
Suspension
Steering
Brakes
Body
The air conditioning system
Electrical equipment
Technical data
Charging System
Checking the voltage drop across the wire connecting the battery to the generator (engine V6)
Check of the current generated by the generator
Check voltage release
Checking the voltage drop across the wire connecting the battery to the generator (the engine 2,0)
Check of the current generated by the generator (engine 2,0)
Checking the generated voltage (2.0 liter engine)
Generator
Accumulator battery
Inspection of battery
Starting system
Removing and installing starter
Installing Transceiver
Removal and installation of remote control
Removal and installation of the audio unit
Multifunction switch
Circuit breakers
Device combination
Switch position of the parking brake
Rear Defrost
Wipers and windshield washer
Airbags (SRS)
Warning Labels
Airbag and a spiral wire
The front passenger airbag
Troubleshooting charging system
Troubleshooting engine starting system
Electrical diagrams
 


Hit Counter by Digits


print page printable version

Wipers and windshield washer



Withdrawal

PERFORMANCE ORDER

1. Remove the cover and turn the wiper arm nuts. Remove the wiper arms.

When removing wiper arms not to scratch the hood.

2. Open the hood.

3. Remove the nut, loosen the clamps and remove the vent chamber at the base of the windshield. Disconnect the connector and remove the engine and pull the wiper.

Check the frequency of wiper

PERFORMANCE ORDER

1. Unplug the connector from the wiper motor.
2. Additional wires connect the positive battery terminal to terminal 6 of the connector and the negative terminal - to terminal 3.
3. Make sure that the wiper motor operates at low speed.
4. Additional wires connect the positive battery terminal to terminal 6 of the connector and the negative terminal - to terminal 2.

5. Make sure that the wiper motor runs at high speed.

Checking the brushes for automatic stop in the initial state

PERFORMANCE ORDER

1. Turn the engine at low speeds.
2. Disconnect the 3 connectors, stop the engine in any position other than the original.
3. Connect terminals 3 and 5 of the connector.
4. Additional wires connect the positive battery terminal to terminal 6 of the connector and the negative terminal - to terminal 1.

5. Check that the wiper motor is switched off in the starting position of the wiper blades.

Testing the engine washer

PERFORMANCE ORDER

1. With the washer motor connected to the washer tank, fill the washer tank with water.

2. Additional wires connect the positive terminal of the battery to terminal 2 and the negative terminal - to terminal 1, the engine must be running and the pump to pump water.





« previos page
Rear Defrost
next page »
Airbags (SRS)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.