REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Rio (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Rio
		Instructions
		Engines A3E, A5D
		Greasing system
		Cooling
		Fuel system
			Technical data
			Fuel system
			Ignition timing
			The idle speed
			Air flow meter sensor
			Knock sensor
			Throttle Position Sensor
			Check the main relay
			Checking the fuel pump relay
			Check the voltage of the front and rear heated oxygen sensors
			Checking the front and rear heated oxygen sensors
			Removing the pressure in the fuel system
			Fuel lines
			Activation of the fuel system
			Check of residual pressure in the fuel system
			Check fuel lines
			Checking the fuel injector
			Quick connections
			Fuel pump
			:20. Fuel tank
			Check crankcase ventilation (PCV)
			Checking system EVAP
			Check valve system EVAP
			Check of the valve closing of the canister
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Wheels and tires
		Steering
		Brakes
		Body
		The air conditioning system
		Electrical equipment

Air flow meter sensor

Withdrawal

PERFORMANCE ORDER

1. Unplug the connector from the air flow sensor.

A warning

Do not drop or bump the sensor, as this will damage it.

2. Loosen the hose clamps of the air intake pipe on both sides of the air flow sensor.

3. Disconnect the air inlet of the air flow sensor.

4. Remove the two screws on the air flow sensor to the bracket.

5. Remove the air flow sensor.

Check

PERFORMANCE ORDER

1. Visually check the air flow sensor for damage. If necessary, replace it. Attach the air flow sensor in the air intake pipe and the bracket.
2. Replace the two screws on the sensor to the bracket. The inhaling moment: 7,8-10,8 N ??? m
3. Connect the sensor air inlet.
4. Tighten the clamps on both sides of the sensor.
	5. Connect the connector to the air flow sensor.
6. Start the engine and warm it up to normal operating temperature. Leave the engine running at idle speed.
7. Connect a voltmeter between terminal 2 (cable G / L - green / light) and ground.
8. Make sure the voltage varies between 0.6-0.8 V.
9. Turn the engine off and make sure that the voltage is in the range 3.0-4.0 V.
	10. If the voltage is not correct, replace the sensor, air flow meter.

« previos page
The idle speed

next page »
Knock sensor