printable version

Airbag and a spiral wire

Airbag and a spiral wire

Spiral wire (spring) consists of two conductive coils and rassolozhena between the steering wheel and steering column, and provides rotation of the steering wheel while maintaining continuous contact block deployment of airbags. The steering wheel should be mounted on the steering column in a neutral position of a spiral wire, as otherwise possible breakage of the connecting wires and the appearance of other defects.

Service airbags must be carried out properly in order to avoid personal injury when airbags deploy unauthorized driver or front passenger.

Do not perform maintenance airbags or electrical components connected with the airbag.

Before servicing the airbag system, make sure that it has been at least 30 seconds after the ignition is turned off and disconnect the wire from the negative terminal of the battery.

PERFORMANCE ORDER

1. Disconnect the negative battery terminal. 2. When disconnecting the electric socket of a spiral wire airbags install the retaining device on the connector outward. 3. When disconnecting the electric socket of a spiral wire from airbag pull out the airbag. A warning When disconnecting the electric socket of a spiral wire of a pillow of safety, do not apply a lot of effort. The removed air bag should be stored in a clean, dry place, face up. 4. Remove the steering wheel. A warning Do not tap on the steering wheel, as this may damage the protective mechanism of the steering column and reduce the degree of protection of the driver in a frontal collision.