printable version
Windshield Wiper Motor
Windshield and rear window 1 - grille hood; 2 - the wiper arm of the windscreen; 3 - windscreen wiper motor; | 4 - pull the windshield wiper; 5 - rear window wiper arm; 6 - rear window wiper motor. |
Check the frequency of wiper PERFORMANCE ORDER | 1. Unplug the connector from the wiper motor. | 2. Additional wires connect the positive battery terminal to terminal 4 of the connector and the negative terminal - to terminal 1. | 3. Make sure that the wiper motor operates at low speed. | 4. Additional wires connect the positive battery terminal to terminal 4 of the connector and the negative terminal - to terminal 2. | | 5. Make sure that the wiper motor runs at high speed. |
|
Checking the brushes for automatic stop in the initial state PERFORMANCE ORDER | 1. Turn the engine at low speeds. | 2. Disconnect the wires from pin 1, stop the engine in any position other than the original. | 3. Connect pins 1 and 5 of the connector. | | 4. Additional wires connect the positive battery terminal to terminal 4 of the connector and the negative terminal - to terminal 3. | 5. Check that the wiper motor is switched off in the starting position of the wiper blades. |
|
Adjustment PERFORMANCE ORDER | 1. Install the wiper arm on the axis in the starting position. | 2. Screw the arm nuts and tighten them to the specified torque. Torque: 18-22 N ??? m | | 3. Place the lid on the nut and check the windshield wiper. Wiper blades should stop in a starting position at a distance of 41 mm from the front passenger, and - 40 mm from the driver. |
|
|