printable version
The front passenger airbag
A warning Do not disassemble or repair the components of an airbag system.
If an airbag has been dropped or it is exposed to water, grease or oil, and if there are cracks, dents or other defects in the hull or connector, replace the airbag.
The removed air bag should be stored in a clean, dry place, face up. Do not place in the airbag foreign objects that the deployment of the airbag can cause serious injury.
Do not expose the air bag to a temperature above 93 ?� C.
Do not attempt to measure the circuit resistance of the pyrotechnic gas generator airbags as possible unauthorized deployment of the driver's airbag.
After airbag deployment should be replaced with a wire that has been exposed to the gases of the pyrotechnic gas generator.
PERFORMANCE ORDER | |
1. Disconnect the negative battery terminal. | A warning Before servicing the airbag system, make sure that it has been at least 30 seconds after the ignition is turned off and disconnect the wire from the negative terminal of the battery.
| 2. Remove the glovebox. | 3. Disconnect the electrical connector airbags. | 4. Remove the airbag. |
|
Troubleshooting charging system and Solutions
Step | Check | Remedy | 1 | Check the battery Voltage: about 12.4 | Yes | See the next step | No | Check the battery | 2 | Start up the engine and check whether the warning lamp lights up battery charging | Yes | See step 4 | No | See the next step | 3 | Check whether the correct voltage on the generator terminals | Yes | Check the condition of the wire connecting the battery and the contact in the generator | Contact | Ignition ON ON, The | Voltage, | No | Check the condition of the wires Replace generator
| B | About 12 | 14,1-14,7 | L | About 1 | 14,1-14,7 | S | About 12 | 14,1-14,7 | 4 | 1. Turn on the ammeter (with a limit of measurement at least 80A) between terminal B and terminal B wires 2. Start up the engine 3. Turn off all electrical consumers and press the brake pedal 4. Check that the device shows the current 65 A or more at a speed of 2500-3000 min -1
A warning Do not connect with "mass" in touch
| Yes | The charging system in order
| No | See the next step | 5 | Make sure the alternator drive belt tension in order | Yes | Replace generator | No | Adjust the tension of the alternator drive belt |
Troubleshooting System start-up and troubleshooting 001 The starter does not turn the engine crankshaft Step | Check | Remedy | 1 | Check whether the crankshaft rotates the motor with a fully charged battery | Yes | Check the charging system | No | See the next step | 2 | Check the voltage supplied to the terminal in the traction relay | Yes | See the next step | No | Check the condition of the wires | 3 | Check up, whether the battery voltage to the terminal S of the traction relay when the clutch pedal is depressed (on cars with manual transmission) or the selector lever in position Park (on vehicles with automatic transmission) and turn the ignition key to the START position | Yes | Replace starter | No | Check the lock switch starter clutch pedal position (on cars with manual gearbox) Check the transmission range switch (on cars with automatic gearbox) Check the ignition switch Check the condition of the wires |
002 Starter motor rotates rapidly
Step | Check | Remedy | 1 | Check and stir if freewheel gear when the starter (When the starter will hear) | Yes | Remove the starter and check the condition of the teeth on the overrunning clutch and flywheel | No | Replace starter |
4 crankshaft rotates slowly Step | Check | Remedy | 1 | Check engine speed with a fully charged battery | Yes | Believe charging system | No | See the next step | 2 | Check for loose wires starter and their lack of corrosion | Yes | Repair or replace wires | No | Check jamming the starter motor. Repair or replace the starter |
11 Control lamp charging lights when the engine is running Step | Check | Remedy | 1 | Check the battery voltage at idle speed Voltage 14,1-14,7V | Yes | Check the condition of the wires connecting the battery and the generator L terminal, a generator and a test light | No | Believe charging system |
004 A discharged battery Step | Check | Remedy | 1 | Believe charging system | Yes | Turn on the ignition and check the current value Current: Less than 20 mA | No | If necessary, replace or repair parts |
|