add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Rio (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks
Kia Rio
Home
 
Kia
Rio
Instructions
Engines A3E, A5D
Greasing system
Cooling
Fuel system
Ignition system
Coupling
Transmission
Axes and power shafts
Suspension
Wheels and tires
Steering
Brakes
Body
The air conditioning system
Electrical equipment
Technical data
Electrical circuits
Generator
Accumulator battery
Starter
Check while cranking the engine is not warmed-up engine
Check the electrical circuit of the traction relay
Check of the traction relay
Check of brushes and brush holder
Checking the stator coils
Check rotor
Removing and installing starter
Repair of starter
Multifunction switch
Sound signal
Fuse and relay, established in car salon
Check the door lock switch activator
Check of the switch of adjustment of position of the door mirror
Check activator position outside rearview mirror
Checking the engine window
Check the rear window defogger
Repair of a current-carrying strip of a heater
Windshield Wiper Motor
Washers
Adjusting headlights
Adjustment of light fog lights
Airbags (SRS)
Warning Labels
Airbag and a spiral wire
Check airbags
Checking the spiral wire (spring)
The front passenger airbag
Electrical circuits
 


Hit Counter by Digits


print page printable version

Washers



Washers

1 - washer tank;
2 - The engine of a washer;
3 - washer hose;
4 - sprayer.

Windshield wiper and washer, rear window

1 - Wiper;
2 - the wiper arm;
3 - wiper motor;
4 - The engine of a washer;
5 - a hose;
6 - spray gun;
7 - washer tank.

Check

PERFORMANCE ORDER
1. Fill with water or a special liquid washer tank.
2. Additional wires connect the positive terminal of the battery to the terminal and connector and the negative terminal - to terminal b, or c.
3. Check the windshield washer motor, with sprays of jets of water should go.

Adjustable jets of water on the windshield

PERFORMANCE ORDER
1. The spray nozzle must apply a jet of water on the windscreen in the area shown in the figure. To adjust the direction of the jet of water with a pin or needle, turn the spray nozzle.
2. If the nozzle is dirty, clean it with a needle or a thin steel wire.

Adjustable jets of water on the rear window


The nozzle sprays a jet of water must be supplied to the rear window in the area shown in the figure.

To adjust the direction of the jet of water with a pin or needle, turn the spray nozzle.

Checking the rear window washer switch

Check for continuity between the switch contacts in all switch positions.

If the conductivity between the contacts does not correspond to that shown in the figure, replace the switch.




« previos page
Windshield Wiper Motor
next page »
Adjusting headlights

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.