|
|
 printable version
Check the steering pump pressure
 | Do not hold the steering wheel with the engine running in extreme positions for more than 15 seconds! |
| - Disconnect the pressure line from the hydraulic path of gear and connect the measuring set - a set of valves must be connected to the steering mechanism. Couplings should be tightened to 31 ÷ 47 Nm.
 |
- Follow the procedure of "pumping" of a hydraulic path (see. Section Bleeding from the working path hydrostrengthening steering system).
- Fully open the gate valve is connected to the system, then start the engine a few times and turn the steering wheel from lock to lock with the purpose of warming up the hydraulic fluid up to normal operating temperature (50 ÷ 60 ?� C).
- Raise the engine speed up to 1000 ÷ 1500 per minute, close the valve and read pressure gauge - the desired value is 6860 ?� 98 kPa (70 ?� 1 kg / cm 2).
- ?????????�?�?�?�?� ???????�???????�?� ?????�?�?????� ?????�?�???? ???� ?????????� ???? ?????????�, - ???????�?�?�?????� ???�???????�?�???� ?????�?�???? ?????�?�?�?????? ?????�?�??????. Close the valve and running, with turnover in 1000 ÷ 1500 min-1 engine, turn the steering wheel from lock to lock - pressure gauge reading should remain the same.
| To avoid overheating of the hydraulic fluid does not hold the valve closed for more than 15 seconds! |
- Stop the engine, remove the pressure gauge and valve and restore initial connection of the hydraulic lines, tightening the choke sockets with demanded effort (31 ÷ 47 Nm).
- In conclusion, the "pump" hydraulic path (see. Section Bleeding from the working path hydrostrengthening steering system).
|
|
|
|
