printable version
Check and adjustment of drive cable AT
Petrol models Check | - Visually check the condition of the sheath, - in case of damage, replace.
- Depress the pedal until it stops and make sure in the fullness of the opening of the engine throttle. If necessary, make the appropriate adjustments.
|
|
Adjustment | - Press the left and a little rubber boot - before the sensation of light resistance - pull and lock the cable core.
- Measure the gap control, - the desired value of 0.8 ÷ 1.5 mm. If applicable, loosen the lock nut and make an appropriate adjustment by rotating in the appropriate direction of the adjusting nut. Finally, do not forget to tighten the lock nut with the required torque (2 ÷ 3 Nm).
|
|
Diesel models See. Section Removal and installation of the gas pedal, adjust the throttle wire in Chapter Power supply systems, engine control / emission control and exhaust.
|