|
|
 printable version
Removing and installing bumpers
Front bumper Details of the installation of the front bumper
| - Remove the bumper gryazeotboynik.
- Remove the two (left and right) of the upper side of the bumper bolts.
 | - Remove the side support brackets for the bumper.
|
 | - Give four mounting waste nuts.
|
- Carefully remove the bumper of the car - it is wise to take the help of an assistant.
- Release sixteen clips fastening facing panels and bumper amplifier. Divide bumper into three sections (cladding, polymer damper and amplifier).
- Visually assess the state of wall panel and a polymeric damper shock absorption. Defective components replace.
- Installation is performed in reverse order Ensure compliance Specifications Chapter Body to the efforts of a tightening of threaded fasteners.
|
|
Rear bumper Details of the installation of the rear bumper (1 of 2)
 | Details of the installation of the rear bumper (2 of 2). |
| - Remove the two mounting bolts and remove the bumper gryazeotboynik.
- Take the four (two on each side) adjusting nut effluent from underneath the bumper.
- Disconnect wiring lights license plate light and reversing lights.
- Remove the bumper.
- Release seventeen clips fastening facing panels and bumper amplifier. Divide bumper into three sections (cladding, polymer damper and amplifier).
- Visually assess the state of wall panel and a polymeric damper shock absorption. Defective components replace.
- Installation is performed in reverse order Ensure compliance Specifications Chapter Body to the efforts of a tightening of threaded fasteners.
|
|
|
|
