 printable version
Removal, installation and adjustment of components of the device cleaning and washing of windshield
Removal, installation and adjustment of components of the device cleaning and washing of windshield Scheme of the windshield cleaning Replacement brush | - Pull the lever on the brush to be replaced windscreen.
 | - Press the locking tab in the lock and remove the brush from the last hook on the end of the arm.
|
- When planting brush lever track reliability latch it closed.
|
|
Withdrawal Levers of screen wipers with brushes | - Make sure that the windscreen wipers are in the "parking" position - if necessary, switch on the ignition, start again and stop the wipers.
 | - Remove the cap, release the retaining nut and remove the arm from the spindle drive traction.
|
|
|
The electric motor drives the wiper |  | - Open the hood and remove the four bolts securing the wiper motor drive.
|
- Disconnect the wiring.
 | - Separate the motor assembly from the fairing panel and prying with a screwdriver, separated from it by a drive rod wiper.
|
- Remove the electric motor.
|
|
Traction Drive Wiper | - Remove the six mounting screws, release the two catches and remove the grille (see. Section Removal and installation of the cowl grille).
- Give fixing bolt and a nut and, acting on the left side of the car, remove the drive rod assembly wiper cowl panel.
- Manually check rotation articulations freedom of assembly, if necessary, add lubricant.
|
|
The tank and the pump supplying washer fluid | - Disconnect the negative wire from the battery.
- Disconnect the electrical wiring of the pump and fluid hose.
 | - Turn out fixing bolts and remove a tank mounted with a pump from the engine compartment.
|
|
|
Setting |  | - Installation is in the reverse order. Make sure the correct state when connected to an electric motor drive him thrust - brush after installation must be in the "parking" polozhenii.Ves fixture tighten with demanded effort.
|
|
|
Adjusting washer fluid nozzles feed |  | - Adjustment is made by turning the jet nozzle introduced his work bore needle - jet should fall into the right place on the glass.
|
 | To avoid breaking of a needle in a jet, you should first "release" in the heat of the flame lighters. |
|
|
|
