| 1. lubricating oil of the engine at a high flow rate of the oil, check where the oil flows. |
| 1a. Open the oil filler cap and check the seal on the absence of porosity or damage. |
| 1b. Crankcase ventilation system, for example, the ventilation hose from the cylinder head cover to the throttle body. |
| 1c. Seal the cylinder head cover. |
| 1d. Seal the cylinder head. |
| 1e. The seal of the oil filter: oil filter cap. |
| 1e. Oil drain plug (O-ring). |
| 1g. The seal of the oil pan. |
| 1h. Seals the front and rear camshaft and crankshaft. |
| 2. Since the presence of leaks in most cases the oil is distributed over a relatively large area of the engine, then, at first glance, it is impossible to determine the oil leak. When searching it is advisable to proceed as follows. |
| 2a. Wash the engine. To do this, spray the engine is a standard low-temperature detergent and rinse after a brief excerpts water jet. Pre-close plastic generator cover. |
| 2b. Pollinate lime powder or talc place of separation and seal the outside of the engine. |
| 2c. Check the oil level, if necessary add oil. |
| 2d. Perform a test drive. Since the oil when the engine is hot becomes liquid and thus will be more likely to leak points, then the test drive should be carried out in the interval of about 30 km on the highway. |
| 2d. Then, inspect the engine lighting bulb, place loose localize and eliminate defect. |
