 printable version
Removal and installation of auxiliary thrust front suspension
 | Set up the auxiliary traction |
| - Remove shock absorber and a spring front suspension.
- Lock the drives internal eccentric bolt the lower control arm with respect to the cross, and then unscrew and remove the nut and bolt wheels.
- Remove the bolt of the auxiliary thrust to the body.
- Remove the bolt support cup spring to the lower control arm.
- Fix the position of the auxiliary traction relative to the lower control arm, and then unscrew and remove the connecting bolt.
- Remove the lower arm of the cross, turn it on and remove the auxiliary traction.
- Spend auxiliary thrust fault detection. With the help of the control (metal) line, make sure that the link is not bent.
- To replace the hinge mark the first position of the ball stud, then loosen the clamp bolt and remove the pin and the ball joint. Wrap the new hinge at the marked position - when installing a = 14.0 mm.
|
|
Installation is the reverse order of removal. It should not be definitively tighten nuts and bolts to full suspension of loading weight of the vehicle. Finally, check the front axle, in particular a longitudinal angle of inclination of the axis of rotation, which is regulated by the auxiliary traction.
|
