printable version
Removal and installation of the front suspension assembly
| - Remove the shock absorbers and suspension springs (see. Removing and installing the front suspension springs and Check, removal and installation of shock absorbers).
- Remove the nut Tie rod and with the help of a stripper separate tip rod from the steering knuckle.
- Disconnect the brake caliper and the brake hose flexible wire wear of brake linings (see. Hoses and pipes).
- Remove the bolt of the support arm to the bottom of the body.
- Substitute under suspension jack-trolley.
- Put labels of mutual position of inner eccentric disc bolt the lower control arm with respect to the cross, and then unscrew and remove the nut and bolt wheels.
- Unscrew anti-roll bar to the upper suspension arm. Note the position of washers and rubber bushings.
- In the engine compartment, unscrew the nut, lock position and press out the inner hinge pin of the upper control arm.
- Print the front suspension assembly from under the vehicle.
- Spend fault detection parts, pay special attention to the rubber products, and if necessary, replace them.
|
|
Installation is the reverse order of removal. Note pumping the brake system and the installation of the front wheels, especially their collapse.
|