printable version
Removing and installing upper suspension arm
| - Prepare the car, holding the lower suspension arms on the supports.
- Remove the nut and the upper ball joint puller separate upper control arm from the steering knuckle. Take a fist to the side and secure it on the car.
- Remove the bolt fastening of the stabilizer to the upper suspension arm, noting the position of washers and rubber bushings.
- In the engine compartment, unscrew the nut and press out the inner hinge pin, noting its position relative to the direction of motion.
- Remove the upper control arm of the car and spend his fault detection.
- In case of wear of the rubber bushings can be replaced by a length of metal pipe of desired length, the long bolts and gaskets.
- To facilitate the installation of new hubs of recommended immersed in soapy water.
|
|
Installation is carried out in reverse order. Finally, check the front axle. | Position sleeve during installation |
|