| Right gland (gland cover chain drive) |
| 1. Remove the crankshaft pulley. |
| 2. Carefully remove the gland, hooked his big screwdriver without damaging the oil pump gears and cover. |
| 3. Clean the stuffing box and remove all burrs and sharp edges, which may be the main cause of the destruction of the gland. |
| 4. Lubricate sealing lips of new oil seal with a thin layer of grease, carefully packing into place so that the jaws were working edges inward, not to damage the oil seal lip. Fitting the mandrel gland until it stops in the shoulder on the periphery of the gland. The mandrel diameter should be such that the pressing mandrel rested against the outer edges of the gland. When pressing the workers not to damage the oil seal lip. |
| 5. Remove any grease, then install the crankshaft pulley. |
| The rear seal (oil seal flywheel / drive plate torque converter) |
| 6. Remove the flywheel (or a leading disk of the torque converter). |
 | 7. Use a large flat-blade screwdriver to pry the oil seal over the inner edge and evenly remove the seal from the cylinder, it does not damage the surface of the crankshaft and the engine block. |
| 8. Clean the lip seal and remove all burrs and sharp edges, which can primarily cause damage to the gland. |
| 9. Grease working edges of a new shaft seal and sealing crankshaft journal with a thin layer of grease, oil seal properly orient the relatively crankcase. |
| 10. hands without using any instrumenov gently put workers on the edge of the gland sealing crankshaft journal. Press in the oil seal is straight all the way to the periphery of the collar in an annular gland tide on the crankcase, crankshaft / cylinder. If necessary, allowed to precipitate the gland at the place of light hammer blows with soft brisk. |
| 11. Remove any grease, then install the flywheel (or a leading disk of the torque converter). |
