| 1. Disconnect the negative battery terminal. |
| 2. Remove the air filter housing (see. Subsection 6.3.1.2). |
| 3. Walk along the wire from the injector to connect and disconnect the connector. |
| 4. Release the pressure from the fuel system (see. Subsection 6.3.1.7). |
| 5. Remove the two screws injector cap, then remove the cap and seal. |
| 6. Remove the injector from the throttle body and remove the sealing gaskets. |
A warning  The injector can sit firmly in its nest. In this case, do not try to pull it out of the wires. Remove the top part of the throttle body injector and push out of the nest.
|
| 7. If the injector to be replaced, it is necessary to release it from the connector wire connection. |
| 8. To do this, remove the retaining clip back connector connection, then use a small screwdriver to release the appropriate wires and push the terminals of the connector connection. |
| 9. Remember or mark the installation position of each of the wires in the plug connection and try not to damage the wiring terminals when removed. |
| 10. If you do not want to disassemble the connector connection, the injector can be removed with the device to increase the speed of the engine idling and the additional air supply valve. |
| 11. Installation is spent upside-down removals. |
| 12. Installation should pay attention to the following points. |
| 13. Establish a new sealing washer and injector seals as well as new gaskets for the cap of the injector. |
| 14. When installing a new injector, insert its terminal wires into the appropriate slots on the socket connection. |
| 15. Make sure that they are securely fastened, and then install the retaining clip connecting the rear connector. |
| 10. Make sure the wires correctly located in the socket connection. If not, then connect the injector connection will not work correctly. |
