.1 - The upper part of the intake manifold. The upper part of first inlet attached to the bottom portion of the inlet manifold, and then into the manifold assembly to the cylinder head; 2 - the throttle body; 3 - a bolt, 10 Nm; 4 - a cover; 5 - the cylinder head cover. When replacing the cover, on the perimeter of the cover in the segment recess, apply sealant WV-D454300A3; 6 - an arm; 7 - a bolt, 25 Nm; 8 - bolt cylinder head. When installing it is necessary to use new bolts and tightening bolts make in a certain sequence in several stages; 9 - cylinder head. When flatness of 0.1 mm is necessary to make regrinding of the cylinder head. Minimum permissible height of the cylinder head 139.5 mm; 10 - the O-ring. When installing, use a new O-ring lubricated with clean engine oil; | 11 - a cover of the drive chain. Removing and installing timing chain cover may only be installed on the cylinder head. When replacing the cover of the drive chain is necessary to fill the holes in the end cap sealing fluid VW-AMV18800102; 12 - chain tensioner, 40 Nm. The engine can be turned only with the established chain tensioner; 13 - a sealing ring; 14 - the water pump; 15 - the block of the ignition system; 16 - the cover of the thermostat; 17 - a sealing ring. If tightness is necessary to use a new sealing ring; 18 - cylinder head gasket. When installing, use a new cylinder head gasket; 19 - lower part of the intake manifold; 20 - to seal the upper portion of the inlet manifold. If the damage is necessary to use a new seal; 21 - bolt 5 Nm; 22 - combined valve; 23 - to seal the bottom portion of the inlet manifold. If the damage is necessary to use a new seal; 24 - V-belt tensioning mechanism; 25 - bolt 5 Nm; 26 - an arm; 27 - the vacuum actuator |