add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Golf 4
Home
 
Volkswagen
Golf 4
Instructions
Engine
Cooling system
Fuel System
Exhaust system
Ventilation and heating system
Coupling
Transmission
Suspension brackets and power shafts
Steering
Wheels and tires
Brakes
Body
Electrical equipment and wiring
Incandescent lamps
Electrical circuits
Detection of open circuit
Circuit breakers
Battery
Generator
Starter
Replacement of bulbs of external illumination
Removing and installing additional brake light
Replacement of bulbs of internal illumination
Devices of external illumination
Removal and installation of headlights
Removing and installing the rear light
Adjusting headlights
Removal and installation of the instrument cluster
Removing and installing steering column switch
Removal and installation of switches
Removal and installation of the radio
Removal and installation of tweeters
Removal and installation of low-frequency speakers
Recommendations for telephone installation
Antenna
Check the rear window defogger
Understanding the electrical circuits
Diagrams of car VW Golf since September, 1997
 


Hit Counter by Digits


print page printable version

Devices of external illumination



Elements lights
1 - a cover;
2 - Insert the front turn signal light bulb;
3 - the executive engine of the proof-reader
headlights;
4 - lamp of the forward index of turns;
5 - front fog lamp;
6 - light beam;
7 - spring wire bracket;
8 - the lamp housing;
9 - spring wire bracket;
10 - light beam;
11 - front side light bulb;
12 - Insert the front side light bulbs

The case lights are not repaired and if damaged it must be replaced completely. If the damage is only to the upper mounting plate lights can be replaced individually.

Withdrawal

PERFORMANCE ORDER
1. Remove the front bumper.
2. Unscrew the bolts (arrows) and pull the headlight forward and pull it out of the car.
3. Disconnect the electrical connectors from the headlamp.

Setting

PERFORMANCE ORDER
1. Connect the headlamp electrical connector.
2. Install the headlight into place and secure it with four screws.
3. Install the front bumper.
4. Check and, if necessary, adjust the headlights.

Replacing the upper mounting plate lights

PERFORMANCE ORDER
1. Remove the headlamp.
2. Remove the broken remains of the mounting plate of the lamp housing.
3. Install the spare part mounting plate lights (2) into the light (3) and tighten the screw (1).
4. Install the headlight.




« previos page
Replacement of bulbs of internal illumination
next page »
Removal and installation of headlights

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.