REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 4
		Instructions
		Engine
		Cooling system
		Fuel System
		Exhaust system
		Ventilation and heating system
		Coupling
		Transmission
		Suspension brackets and power shafts
		Steering
		Wheels and tires
		Brakes
		Body
		Electrical equipment and wiring
			Incandescent lamps
			Electrical circuits
			Detection of open circuit
			Circuit breakers
			Battery
			Generator
			Starter
			Replacement of bulbs of external illumination
			Removing and installing additional brake light
			Replacement of bulbs of internal illumination
			Devices of external illumination
			Adjusting headlights
			Removal and installation of the instrument cluster
			Removing and installing steering column switch
			Removal and installation of switches
			Removal and installation of the radio
			Removal and installation of tweeters
			Removal and installation of low-frequency speakers
			Recommendations for telephone installation
			Antenna
			Check the rear window defogger
			Understanding the electrical circuits
			Diagrams of car VW Golf since September, 1997

printable version

Removal and installation of the instrument cluster

Location of electrical connectors on the rear of the instrument cluster

1 - 32-pin electrical
green connector;
2 - 20-pin electrical
The red plug;
3 - fixing device
wiring;

4 - buzzer oil pressure light switch;
5 - a control lamp of a vehicle operating with a trailer 1.12 W;
6 - 32-pin electrical connector blue

A warning

The instrument cluster can only be replaced by an incandescent bulbs. Failure of one of the pointers or the presence of any other defect of the instrument cluster assembly must be replaced.

Withdrawal

PERFORMANCE ORDER

1. Move to the bottom of the steering column and remove the steering wheel.
	2. Release the spring clips from the lower dash trim (1) and remove it through the top cover (2) of the steering column.
	3. Remove the two screws holding the lower part of the instrument cluster.
4. Move the instrument cluster and forth on the reverse side of the instrument cluster, disconnect the electrical connectors.
5. If necessary, replace the bulb.

Setting

PERFORMANCE ORDER

1. Installation is made in sequence, return to removal.

2. If you are installing a new instrument cluster, correct readings Service-indicator and odometer.

« previos page
Removal and installation of the executive engine of the proof-reader of light of headlights

next page »
Removing and installing steering column switch