printable version
Removal and installation of the radio
The factory has a radio pocket, through which facilitated the process of installing and removing the radio. To remove the radio, you must use two special key.
The standard equipment for the car radio set, having an encoded device against theft, which is formed of a microprocessor. After disconnecting the radio from an electric vehicle network (removal of the battery, removing the initial installation of the radio or radio), you must enter the security code. The radio can be enabled only after entering the correct code.
Before removing wires from the battery weight, check whether you have the radio code. In the absence of the security code to enter into operation only radio station dedicated to Volkswagen.
Individual radio security code available in the technical documentation, applied to the sale of the car.
Withdrawal
Setting
PERFORMANCE ORDER | 1. Connect the electrical connectors to the rear of the radio. | 2. Insert the radio into the slot until it clicks into the dashboard of spring clamps. | 3. Connect the ground cable to the battery. | 4. After installing the radio, enter the security code. | A warning On radios with security code on the front button has a red badge in the form of a key.
Individual radio security code available in the technical documentation, applied to the sale of the car. Keep a record of the individual code in a safe place and never keep it in the car.
| 5. Enter the security code radio follows. | 6. Turn on the radio. | 7. Simultaneously press the TR and TA repeatedly until 1000, and then release the keys. | 8. Enter the security code using the station selection keys 1 to 4. The number 1 specifies the first code number, button 2 - the second code number, etc. | 9. Again simultaneously press TR and TA repeatedly until SAVE, then release the keys. Now the receiver is put into operation, and the display shows the frequency of the station. | 10. If a security code has been entered correctly into the receiver, then after removing the ignition key should be flashing LED located next to the name of the radio. | A warning If the radio was wrong security code is entered, the inscription SAVE blinks first, then lights up constantly. Thereafter, only one repeat a process of inputting a security code. When re-enter the wrong security code, the radio will be blocked for an hour and it can not be put into operation. After one hour, during which the receiver must be switched on, repeat input a security code.
|
|
|