REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
		Axes and power shafts
		Steering
		Wheels and tires
		Brakes
			Technical data
			Bleeding the hydraulic system of a drive of brakes
			Checking the brake tubes and hoses
			Replacement brake hoses
			Installation height of the brake pedal
			Free running of the brake pedal
			The distance from the floor of the brake pedal
			Check the brake servo
			Parking brake
			Brake pedal
			The main brake cylinder
			Vacuum brake booster
			Replacing the front brake pads
			Replacing brake pads on the rear drum brakes
			Replacing brake pads on the rear disk brakes
			Parking brake
			Hydraulic control unit (HCU)
			The front wheel speed sensor
			Rear wheel speed sensor
			A gear rotor of the wheel speed sensor
			Repair of the working brake cylinder
			Main inspection
			Checking functionality
			The list of codes of malfunctions of brake system
		Suspension
		Body
		The air conditioning system
		Electrical equipment

printable version

Bleeding the hydraulic system of a drive of brakes

Hydraulic brake system kennels

1 - the vacuum brake booster;
2 - the master cylinder;
3 - the central valve;
4 - expansion tank;
5 - brake fluid level;
6 - the battery is low pressure;

7 - pump unit;
8 - the electric motor;
9 - an inlet valve (NO);
10 - the inlet valve (NO);
11 - exhaust valve (NC);
12 - exhaust valve (NC)

Element kennel hydraulic anti-lock braking system

1 - unit ABS;
2 - damping chamber;
3 - electric motor;
4 - expansion tank;
5 - the master cylinder;
6 - the vacuum brake booster;
7 - the pressure accumulator;

8 - the brake pedal;
9 - the position of the primary piston;
10 - central valve;
11 - inlet valve;
12 - the wheel speed sensor;
13 - Caliper;
14 - exhaust valve

Any hydraulic system works normally if air is removed from it.

PERFORMANCE ORDER

1. Lift the car and fix on support.
A warning The liquid in the tank popolnitelnom braking system must be maintained at ^_3/4 or higher in the course of pumping. During air removal add only the pure liquid recommended by the manufacturer
2. Air removal spend in the following order: - The front right wheel; - The left front wheel; - The right rear wheel; - The left rear wheel.
3. Remove the cap from the bleeder, and connect to it a hose.
	4. Place the other end of the hose in a glass container of sufficient volume.
5. Slowly depress the brake pedal several times.
6. When the brake pedal depressed key OK130 430 019, loosen the bleeder valve and release the air from the hydraulic system.
7. Tighten the bleeder valve and release the brake pedal. Torque: 5,9-8,8 N ??? m
8. Repeat steps 5-7 until then, until a brake liquid without air bubbles.
9. Screw the cap on the bleeder valve.
10. Check the correct operation of the brakes.
11. Check for leaks of brake fluid.
12. Fill the brake fluid in the reservoir popolnitelny brake system.

« previos page
Technical data

next page »
Checking the brake tubes and hoses