REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
		Axes and power shafts
		Steering
		Wheels and tires
		Brakes
			Technical data
			Bleeding the hydraulic system of a drive of brakes
			Checking the brake tubes and hoses
			Replacement brake hoses
			Installation height of the brake pedal
			Free running of the brake pedal
			The distance from the floor of the brake pedal
			Check the brake servo
			Parking brake
			Brake pedal
			The main brake cylinder
			Vacuum brake booster
			Replacing the front brake pads
			Replacing brake pads on the rear drum brakes
			Replacing brake pads on the rear disk brakes
			Parking brake
			Hydraulic control unit (HCU)
			The front wheel speed sensor
			Rear wheel speed sensor
			A gear rotor of the wheel speed sensor
			Repair of the working brake cylinder
			Main inspection
			Checking functionality
			The list of codes of malfunctions of brake system
		Suspension
		Body
		The air conditioning system
		Electrical equipment

Vacuum brake booster

Withdrawal

PERFORMANCE ORDER

1. Remove the brake master cylinder.

2. Disconnect the vacuum hose from the unilateral valve of the vacuum brake booster.

3. In the car, remove the spring pin and remove the pin head and the cotter pin hole.

4. Remove the four nuts of the vacuum brake booster.

5. Remove the vacuum brake booster.

6. Remove the spacer arm of the vacuum brake booster.

Setting

PERFORMANCE ORDER

1. Set the brake servo with a new seal on the bulkhead and secure with four nuts.

Torque: 19-26 N ??? m

2. Set pin with a head and an aperture under the pin and secure it with a new spring cotter pin.

3. From the engine compartment, connect the vacuum hose to the one-way valve of the vacuum brake booster.

4. Install the brake master cylinder to the brake servo and fix two bolts.

Torque: 9,8-16 N ??? m

5. Connect the brake pipes and tighten the nuts connecting tubes.

Torque: 13-22 N ??? m

6. Connect the brake fluid level.

7. Fill the tank popolnitelny brake system with brake fluid up to the MAX mark.

8. Remove air from the hydraulic circuit brake system.

9. Check for leaks of brake fluid.

10. Check and, if necessary, adjust the height of installation of a pedal and brake pedal free wheeling.