REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
		Axes and power shafts
		Steering
		Wheels and tires
		Brakes
			Technical data
			Bleeding the hydraulic system of a drive of brakes
			Checking the brake tubes and hoses
			Replacement brake hoses
			Installation height of the brake pedal
			Free running of the brake pedal
			The distance from the floor of the brake pedal
			Check the brake servo
			Parking brake
			Brake pedal
			The main brake cylinder
			Vacuum brake booster
			Replacing the front brake pads
			Replacing brake pads on the rear drum brakes
			Replacing brake pads on the rear disk brakes
			Parking brake
			Hydraulic control unit (HCU)
			The front wheel speed sensor
			Rear wheel speed sensor
			A gear rotor of the wheel speed sensor
			Repair of the working brake cylinder
			Main inspection
			Checking functionality
			The list of codes of malfunctions of brake system
		Suspension
		Body
		The air conditioning system
		Electrical equipment

printable version

Replacing brake pads on the rear disk brakes

Brake pads rear disc brakes

1 - the parking brake cable and clamp fixing the cable;
2 - connecting bolt;
3 - the brake pipe;
4 - a directing bolt;
5 - a support;
6 - V-shaped spring;

7 - the brake pads;
8 - a lining;
9 - guide plate;
10 - a bolt;
11 - the holder of a support;
12 - piston calipers

Withdrawal

PERFORMANCE ORDER

1. Remove the clip and disconnect the parking brake cable.
2. Remove the connecting bolt of the brake pipe to the caliper.
3. Clamp the rear brake hose.
4. Remove the two screws on the guide carriage.
5. Remove the caliper from the brake disc.
6. Remove the two V-shaped spring mount brake pads.
7. Remove the brake pads, gaskets and guide plates.
8. Remove the two mounting bolts of the caliper.
9. Remove the caliper bracket.

Check

PERFORMANCE ORDER

1. Measure the thickness of the brake pads. The thickness of the brake pads: Rating: 10.0 mm The minimum allowable: 2.0 mm
2. The indicator of hour type measure palpation of a brake disk. Maximum runout: 0.08 mm
3. Measure the thickness of the brake disc. Brake Disc Thickness: Par: 10 mm The minimum allowable: 8 mm

Setting

PERFORMANCE ORDER

1. Install the caliper bracket and secure it with two screws. Torque: 45-67 N ??? m
2. Adjust the guide plates.
3. Install the brake pads and linings, and fasten them with two V-shaped springs.
	4. Special adaptation OK9A4 263 001 press the piston in the caliper, in order to be able to establish a support for new brake pads.
5. Tighten the two screws on the guide carriage. Torque: 29-39 N ??? m
6. Connect to a support a brake tube and secure it with the connecting bolt. Torque: 22-29 N ??? m
7. Install the parking brake cable and secure it with a clamp.
8. Remove air from the hydraulic circuit brake system.
9. Check for leaks of brake fluid.

« previos page
Replacing brake pads on the rear drum brakes

next page »
Parking brake