REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
		Axes and power shafts
		Steering
		Wheels and tires
		Brakes
			Technical data
			Bleeding the hydraulic system of a drive of brakes
			Checking the brake tubes and hoses
			Replacement brake hoses
			Installation height of the brake pedal
			Free running of the brake pedal
			The distance from the floor of the brake pedal
			Check the brake servo
			Parking brake
			Brake pedal
			The main brake cylinder
			Vacuum brake booster
			Replacing the front brake pads
			Replacing brake pads on the rear drum brakes
			Replacing brake pads on the rear disk brakes
			Parking brake
			Hydraulic control unit (HCU)
			The front wheel speed sensor
			Rear wheel speed sensor
			A gear rotor of the wheel speed sensor
			Repair of the working brake cylinder
			Main inspection
			Checking functionality
			The list of codes of malfunctions of brake system
		Suspension
		Body
		The air conditioning system
		Electrical equipment

Hydraulic control unit (HCU)

Hydraulic control unit (HCU)

1 - the brake pipe;
2 - a socket;
3 - bolts;
4 - an arm of the fuse box;

5 - an arm HCU;
6 - hydraulic control unit (HCU);
7 - the screw

Withdrawal

PERFORMANCE ORDER

1. Disconnect the negative battery terminal.
2. Remove the three mounting bolts of the fuse box and remove the fuse box with the hydraulic control unit (HCU).
3. Remove the connector cover from the unit. Pull the release latch and disconnect the connector from the hydraulic control unit.
	4. nakidnym wrench disconnect the six brake lines. Collect leaking brake fluid. Temporarily close the ends of the tubes with plastic plugs to eliminate the ingress of contaminants.
5. nakidnym wrench, remove the three mounting bolts of the hydraulic control unit and remove the bracket.
6. Temporarily close the holes in the plastic plugs to eliminate the ingress of contaminants.
7. Keep the hydraulic control unit in a protective container.

Setting

PERFORMANCE ORDER

1. Set the hydraulic control unit bracket on the car and fix two bolts.

Torque: 19-25 N ??? m

2. Set the hydraulic control unit into place and secure it with three screws.

Torque: 8-10 N ??? m

3. Reconnect the six brake lines. Tighten the nuts connecting tubes.

Torque: 12-22 N ??? m

4. Connect to the hydraulic control unit.

5. Set the main fuse box mounting bracket and secure the three bolts.

6. Remove air from the hydraulic circuit brake system.

7. Check for leaks of brake fluid.

8. Attach the wire to the negative terminal of the battery.

« previos page
Parking brake