REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
		Axes and power shafts
		Steering
		Wheels and tires
		Brakes
			Technical data
			Bleeding the hydraulic system of a drive of brakes
			Checking the brake tubes and hoses
			Replacement brake hoses
			Installation height of the brake pedal
			Free running of the brake pedal
			The distance from the floor of the brake pedal
			Check the brake servo
			Parking brake
			Brake pedal
			The main brake cylinder
			Vacuum brake booster
			Replacing the front brake pads
			Replacing brake pads on the rear drum brakes
			Replacing brake pads on the rear disk brakes
			Parking brake
			Hydraulic control unit (HCU)
			The front wheel speed sensor
			Rear wheel speed sensor
			A gear rotor of the wheel speed sensor
			Repair of the working brake cylinder
			Main inspection
			Checking functionality
			The list of codes of malfunctions of brake system
		Suspension
		Body
		The air conditioning system
		Electrical equipment

Installation height of the brake pedal

Check

PERFORMANCE ORDER

Measure the distance from the center of the brake pedal to the bulkhead.

Adjustment

PERFORMANCE ORDER

1. Unplug the connector from the brake light switch.
	2. Loosen the lock nut B, and turn the switch until it engages the pedal.
3. Loosen the lock nut D and, rotating pusher C, adjust the height of the installation of the brake pedal. If necessary, unscrew the switch to prevent its contact with the brake pedal.
4. Replace the switch so that its plunger was completely drowned in the switch housing, then turn the switch ^_1/2 turn. Tighten the lock nuts B and D.
5. Connect to the brake light switch.
6. Check the operation of the brake light.