REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
		Axes and power shafts
		Steering
		Wheels and tires
		Brakes
		Suspension
		Body
		The air conditioning system
		Electrical equipment
			Technical data
			Electrical circuits
			Circuit breakers
			Accumulator battery
			Check of level and density of electrolit and gymnastics
			Maintenance-free batteries
			Wires and terminals
			Charging standard batteries
			Starter
			The switch of blocking of a starter
			Removing and installing starter
			Repair of starter
			Check of the traction relay
			Check of brushes and brush holder
			Checking the stator coils
			Check rotor
			Generator
			Alternator drive belt
			Removing and installing the generator
			Repair the generator
			Check the rear window defogger
			Airbag
			The front passenger airbag
			Coiled Wire
			Troubleshooting System start-up and troubleshooting
			Electrical circuits

printable version

Coiled Wire

Withdrawal

A warning

Plug the coiled cable is an integral part of the combined switch and served as a separate part.

PERFORMANCE ORDER

1. Remove the driver's airbag.

2. Remove the nut of the steering wheel. Put combination labels on a steering shaft and steering wheel to the right to be reinstalled.

3. A stripper, remove a steering wheel.

4. Remove the three screws that secure the spiral wire, disconnect three connectors and remove the body of a spiral wire.

Setting

PERFORMANCE ORDER

1. Temporarily according to earlier put labels establish a steering wheel and set the front wheels for movement directly forward.

A warning

Alignment pin connector is used the alignment of the spiral wires when installing the steering wheel to the steering column. Alignment pin comes with a new combined switch and is necessary for the installation of the original spiral wire. Alignment pin has a diameter of 3 mm and a length of 76 mm.

2. Install the spiral wire and fasten with three screws.

Tightening torque: 0.92 N ??? m

3. Turn the central part of the spiral wire clockwise until it stops. Turn the central part of the spiral wire clockwise for 2 ^_1/2 turn and align the arrow on the body and the central part of a spiral wire.

4. Insert the alignment pin into the hole from the front side of the central portion of the helical wires so that it fits into the hole on the back side of the housing.

5. Reinstall the steering wheel, combined the labels put before removal and installation missing a finger through the oblong hole in the steering wheel. Screw the nut on the steering wheel and tighten its demanded moment.

Torque: 39-49 N ??? m

6. Install the driver airbag.

« previos page
The front passenger airbag

next page »
Troubleshooting System start-up and troubleshooting