REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 323 (1985 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	323
		Introduction
		Gasoline engines
		Engine oil
		Engine cooling system
		Ignition system
		The power supply system, the carburettor, fuel injection system
		Diesel engine
			The principle of operation of the diesel engine
			Removing and installing toothed belt / adjusting timing gear
			System of preheat of the diesel engine
			Checking the system of preheat
			Removal of air from the power supply system
			Check / replacement of the electromagnetic valve fuel cut
			Adjustment of a drive gas
			Check / adjust the idle speed
			Removal and installation of atomizers
			Removal and installation of the vacuum pump
		Exhaust
		Coupling
		Manual gearbox
		Automatic Transmission
		Suspension and steering system
		Brakes
		Wheels and tires, a body, car coloring, care of the car
		Electrical system
		Heater, illumination system, devices
		Controls and operation receptions
		Electrical diagrams

printable version

Adjustment of a drive gas

PERFORMANCE ORDER

Before adjusting the drive gas, check the idle speed.
The engine should be warmed up to normal operating temperature.

GASZUG very fragile and when you install it should be handled with special care. Even a slight bend may cause breakage of a cable during the operation. Cables which have been bent, need not be installed.

Ask the assistant to squeeze the gas pedal completely (full throttle position), or locked in this position, set between the seat and pedal a wooden block.

At full throttle to adjust the cable on the counter support using the lock nut so that the lever pump rests without stress to maximum stop.
Release the accelerator pedal, the lever pump should now fit the stop idling.

« previos page
Check / replacement of the electromagnetic valve fuel cut

next page »
Check / adjust the idle speed