add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 323 (1985 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 323
Home
 
Mazda
323
Introduction
Gasoline engines
Engine oil
Engine cooling system
Ignition system
The power supply system, the carburettor, fuel injection system
Diesel engine
The principle of operation of the diesel engine
Removing and installing toothed belt / adjusting timing gear
System of preheat of the diesel engine
Checking the system of preheat
Removal of air from the power supply system
Check / replacement of the electromagnetic valve fuel cut
Adjustment of a drive gas
Check / adjust the idle speed
Removal and installation of atomizers
Removal and installation of the vacuum pump
Exhaust
Coupling
Manual gearbox
Automatic Transmission
Suspension and steering system
Brakes
Wheels and tires, a body, car coloring, care of the car
Electrical system
Heater, illumination system, devices
Controls and operation receptions
Electrical diagrams
 


Hit Counter by Digits


print page printable version

Removal of air from the power supply system



PERFORMANCE ORDER

  1. When opening the system or completely empty the fuel tank of the power system is always necessary to remove the air.
  1. Make sure that there is fuel in the tank.
  1. Open valve vent on the fuel filter.
  2. Defined hand pump fuel from the tank. The pump is located on the top of the filter.
  3. Pumped up until the fuel leaving the pumping valve without air bubbles.
  4. When you press the hand pump pumping close the valve.
  5. Pump the hand pump (about 15 times), until when you will not feel the resistance.
  1. If the engine does not start because of an injection pipeline in the airlock, loosen union nuts on injectors and include a starter, to fuel outlet. Then tighten the screws again and start the engine.

Ensure that the diesel fuel gets onto the coolant hoses. If necessary, clean the hoses immediately. Eroded hoses should be replaced.





« previos page
Checking the system of preheat
next page »
Check / replacement of the electromagnetic valve fuel cut

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.