 printable version
Dashboard
Type A - Arrow signs Type B - Electronic indicators  - Speedometer
- Odometer
- Meter run from the date of discharge (if available)
- Button reset the meter run (if available)
- To set to "0" just click.
- The warning lamp turn signals / alarms
- If the warning light does not work, the system is not working satisfactorily direction indicators. It should solve the problem as quickly as possible.
- When the alarm blinkers simultaneously work on both sides.
- Thermometer coolant
- This thermometer indicating the temperature of the coolant.
Type A - Arrow signs If gauge needle came out of the permissible area, the engine overheated. Type B - Electronic signs  When the engine is overheated segments of the indicator flashing. | Take the following actions if the engine overheats: - Stop the car at the edge of the road.
- Turn off the air conditioner.
- Stop the engine if the radiator appears coolant or steam. Turn the ignition key to ?�ON (II)?�, without starting the engine. In this position, the fan runs automatically. If it does not work, contact the service center MAZDA.
- If coolant does not appear, leave the engine running at idle speed for better cooling and open the hood.
- If the temperature is not reduced idling, stop the engine and wait until it cools down.
- Check the radiator hoses for leaks. Immediately stop the engine, if it is found to leak, and contact the service center MAZDA.
- Check the coolant level, if the coolant acts. If necessary, add recommended coolant.
 | Do not remove the radiator cap when the engine and radiator are hot. Boiling coolant and steam can escape under pressure from the hole, which can cause burns. |
|
|
- The fuel gauge
- The fuel gauge indicates how much fuel there is in the tank.
- The fuel tank
- In addition to vehicles with four-wheel drive: 45 l.
- Only vehicles with four-wheel drive: 53 l.
Type A  Type B - Electronic indicators   | - When flashes the lower segment of the indicator supply of fuel, the fuel level in the tank is about 5 liters.
- If the refueling does not turn on the ignition switch, it lasts until the indicator is not set to the current level of fuel. Therefore, when refueling, turn off the switch.
|
- Warning lights
Check  If you set the ignition switch to ?�ON (II)?�, without starting the engine and apply the parking brake, you can check the indicator lamps. If the lights do not light up, they should be checked at a service center MAZDA.  Optical / acoustic
Alarm Low fuel level (if applicable). This optical / acoustic alarm is activated if the fuel tank is 8 liters.  The control lamp of pressure of oil
This warning light indicates too low pressure motor oil. It lights up when the ignition (to check that the lamp), if the oil pressure is normal, the lamp goes out after starting the engine.
| If the warning light illuminates while driving: - Stop the car at the edge of the road.
- Check the motor oil. If necessary, add oil.
- Or drag the car to the nearest service center MAZDA, to add oil.
|
|
| Failure to follow the above stated instructions can result in serious engine damage. |
 The warning lamp / audible signal oil pressure - oil filter (diesel engine)
This warning light illuminates when the ignition (to verify that) and goes out after starting the engine.
| If the oil pressure warning lamp lights up while driving: - Carefully park the vehicle on the side of the road.
- Check the motor oil. If the level is too low, add the missing oil, or
- Drag car brand MAZDA center and add oil there.
|
|
The system control lamp / sound signal of the oil filter also serves to protect the oil filtration system of your car. If the warning lamp / buzzer sounds at a normal temperature of the engine and at a normal level of motor oil, it indicates that the oil filter is clogged possible. In this case, take the car to the nearest gas station or in the corporate center MAZDA, to replace the oil filter. | Failure to follow the above rules may lead to serious engine damage. |
 The control lamp of the charging current
With this light indicates failure of the electrical system or the generator.
| If the lamp lights up during a trip, proceed as follows: - Gently stop the car on the edge of the roadway.
- With the engine off, check whether or not to weaken not damaged V-belt.
- If the V-belt in order, the fault lies in the system charge. It is recommended that as soon as possible to find and correct the problem.
|
|
 The warning lamp alarm (if available)
This lamp lights up when the alarm.  The indicator lamp failure of the brake lights (if available)
The lamp comes on when the failure of a stoplight or a fault in the circuit. The fault should be eliminated as quickly as possible.  The brake warning lamp
The warning lamp Parking brake - if the manual brake is, when the ignition warning lamp. When starting off, check that the handbrake has been completely released and the light goes out.
Control lamp of brake fluid level (if available) If this lamp lights up when you release the hand brake and the ignition on, it may be that the level of brake fluid level is too low. | If the lamp lights up, proceed as follows: - Check whether the hand brake is released. If the brake is released and the lamp continues to burn.
- Gently stop the car on the edge of the roadway.
- With the engine off immediately, check the brake fluid level and add fluid if necessary. All other elements of the brake system should be checked for leakage of fluid.
- If leaks are found places warning lamp remains on or the brakes do not work perfectly, the trip should be discontinued. The vehicle must be towed to the service center to check the brake system and carry out the necessary work.
|
|
| Operation of the vehicle in such a state poses a risk. Brakes should be immediately repaired. |
 The control lamp heating rear window (if available)
The warning lamp lights up when the heated rear window.
 The indicator lamp washer fluid level (when available)
This warning light illuminates if the level of fluid in the windshield washer system is too low. Check the fluid level and top up washer fluid.  The warning lamp the air damper
The warning lamp lights up when the drive button extended the choke.  The indicator lamp beam
The warning lamp lights up when the high beam.  The warning lamp switch to the next gear (if applicable)
If this warning lamp lights up, fuel consumption is too high a gear. In this case, switch to the next gear box to achieve economical fuel consumption.  Control lamp of the gas pedal (if available)
This warning lamp lights up when the gas pedal is squeezed too hard. In this case, reset the gas until the extinguished lamp to provide lower fuel consumption.  The indicator lamp back foggy lanterns (if available)
This warning lamp lights up when you turn back foggy lanterns.  Indicator turbocharger (for cars with turbo)
The indicator lights up when the turbocharger in action
The indicator flashes and alarm sounds when the discharge pressure increases too much. The vehicle should not continue to move the flashing, as the engine could be damaged. In this case, reduce the number of revolutions until the indicator stops flashing turbocharger.  Control lamp of level of a cooling liquid (diesel engine, if available)
| Since the engine is composed of aluminum parts must use coolant based on ethylene glycol. |
| With the ignition on the control lamp lights up to verify that the lamp; It should go out when the engine starts. If the warning light illuminates while driving (or will sound a beep): - Stop the car at the edge of the roadway.
- Turn off the engine and let it cool. If coolant does not leak, check the fluid level in the reservoir and radiator. If necessary, add coolant.
- If the warning light goes out, drag the car to the service center MAZDA.
|
|
 The warning lamp / control signal vodootrazhatelya (for a diesel engine, if available)
Cars with diesel engine | If both indicator lights illuminate the charge, coolant level, brake and vodootrazhatelya, you must take the following steps: - Stop the car at the edge of the roadway.
- Turn off the engine and check for loose or torn whether the V-belt generator.
- If the V-belt generator is defective, in any case can not continue driving, since the engine is overheating and the braking effect of reduced. Have the car towed to the nearest repair shop.
|
- Tachometer
The tachometer indicates engine speed in thousands of revolutions per minute (rev / min). | Do not run the engine in the red part of the tachometer. This can lead to serious engine damage. |
Type A  Type B  - Switching display fuel level indicator (only on electronic indicators if available)
Pressing the button will be displayed indicating to the lower area of between 5 and 15 liters. After about 5 seconds, the LED will return to its original, normal state.  
|
