printable version

Other instruments and equipment

Unlocking the bonnet

PERFORMANCE ORDER

The hood is unlocked if pull the locking button. Unlock and lift the hood. Support the hood stop. Before closing the hood, remove the emphasis in the holder. Lower the bonnet and allow it to snap into place.

Office lighting instrument panel (if available)

By rotating the wheel controller is set brightness dashboard.

System of adjustment of ride height (vehicles with four-wheel drive, if available)

With this system the car can be set "higher" or "deeper" in accordance with the road conditions. When load changes, for example, when embarking or disembarking passengers and when loading and unloading, the exposed ground clearance is set automatically.

Control

TIEF ?�Low" during normal driving conditions and trips on the highway when the ignition is set to "Low." In this case, indicator lights ?�LOW?�.

HOCH ?�High" on rough country roads or when the ignition is set to "High." In this case, indicator lights ?�HIGH?�.

Note

1. If the ground clearance is switched from the "low" to "high" during the installation indicator flashes .
   When the height is set, the red light.
2. Setting "Low" or "High" corresponds to approximately 20 mm deeper or 10 cm higher level than the standard ground clearance vehicles with two-wheel drive.

If both indicators are flashing ?�HIGH?� and ?�LOW?�, the system may be malfunctioning, or may be the following issues: The car is loaded with a weight of over 350 kg (passengers and luggage). The car is tilted due to uneven load or road conditions. If the problems listed in the previous two points are not available, then the system is faulty. Please contact the service center MAZDA.

Be careful when adjusting the ride height while driving. Do not set the ride height is higher if you are moving at high speed, or are in the rotation.

Heated rear window (if available)

Rear window heater when the ignition (ignition key in position ?�ON (II)?� can be enabled by pressing the switch.

When the heated rear screen warning light.

Do not clean the rear window wipers for glasses, sharp objects or abrasive cleaners, as they may be damaged heating wire.

Rear window cleaner (if available)

Rear window cleaner can be turned on with a switch.

Rear window washer system (if available)

Washer fluid is sprayed on the rear window, as long as the switch is pressed. If the liquid is not sprayed, you must check the fluid level in the reservoir.

If a full tank of liquid is not sprayed, check the washer system in workshop MAZDA.

Headlights washer system (if available)

The washing liquid is sprayed on the glass headlights, when the switch is turned on with the ignition.

Headlights washer system should not work longer than 10 seconds.

Electronically controlled shock absorbers (if available)

Adjustable dampers can be installed in three different positions ?�SPORT?�, ?�NORMAL?� and ?�CRUISE?�.

Control Switch

?�SPORT?�

To improve the dynamic characteristics of the shock absorbers should be all set to Hart (hard).

?�NORMAL?�

For soft dynamic characteristics of all dampers should be installed mode Weich (soft).

?�CRUISE?�

To improve stability at high speeds, the front shock absorbers are set to hart, and the rear shock position weich.

Digital clock (if available)

Setting the time

Turn the ignition switch to ?�ON (II)?�.

RESET - If you press RESET, minutes indicator will be set to zero. Releasing the key will be exactly set the full hour.

For example, if you press the RESET button during the 9:01 - 9:29 Reading install 9:00 between 9:30 - 9:59 will be set 10:00.

Thus, it is possible, for example, the exact time for the radio signal.

HOUR - If you press the HOUR, change the hours.

MIN - If you press MIN, to change the minutes.

Cigarette lighter

The cigarette lighter is activated by pressing it. When it warms up, it jumps back and can be used. When the engine ignition switch must be set to ?�ACC (I)?�, to use the cigarette lighter.

Do not hold the lighter down, as it may overheat.

Only use the cigarette lighter MAZDA. It is not recommended to connect to the cigarette lighter socket, no electrical appliances, such as a razor, coffee, etc. as the slot may be damaged.

Ashtray

To remove the ashtray, you can pull it out and push spring. Close the ashtray, if you are not using it.

Do not use the ashtray as a waste container.

Rear ashtray (if available)

To remove the ashtray, open the cover and pull it out.

Glovebox

To open, pull the lid down.

If the cover has a lock, insert the key and open the lid, turn it to the left.

For your safety while driving glove box lid must be closed.

The parcel shelf (if available)

Open shelf.

Coin (if available)

To open pull the Coin.

Do not use as an ashtray for coins.

Rear lights dim (if available)

In order to avoid rear-end collisions in poor visibility, such as dense fog foggy lights turn back. To turn off again press the switch.

Side vents of fresh air

Air flow can be adjusted with a lever.

The air coming from the side vents of fresh air, depending on the vehicle speed.

Incoming air depends on the fan speed.

When the air conditioner, set the lever to the