 printable version
Radio
| 51. Dismantling keys | A2. Radio |
Withdrawal
A warning  As standard established and acquired in trade receivers have a code number. It protects the receiver against unauthorized use. After switching on the radio must be in accordance with the operating instructions to enter the code number, otherwise it can not be included. If the radio is coded, then define the radio code before disconnecting the wires from the battery terminals or her removal. If the code is not known, enter the car radio in operation can only manufacturer. The individual code number is listed in the passport of the radio. This certificate should not be stored in the car.
| PERFORMANCE ORDER | 1. Disconnect from the terminals of the battery ground cable (-).
A warning This erased anti-theft radio code.
| | 2. Slide the two key demolition (51) and remove the radio (A2). | | 3. Press the locking spring (arrow) and pull out the dismantling key. | | 4. On the back side of the radio label the wires with tape and remove them. |
|
Setting | PERFORMANCE ORDER | | 1. In the production car does not install the antenna cable and the antenna line with its remote control extension, they need to spend extra. | | 2. Connect the wires behind the radio according to the marking in accordance with the manufacturer's instructions. | | 3. Insert the radio with a push into the hole of the console. | | 4. Connect to the terminal of the battery ground cable (-). Set the clock and program the anti-theft code for the radio. |
|
Instructions for retrofitting the radio
A warning If you do not use the serial connecting cable, be sure to pay attention to the fact that no bare wires loose. Otherwise, a short circuit will blow the wire. In the shops you can buy adapters to connect the radio.
Pay attention to apply only type-tested set of components (inductors, capacitors) for interference suppression (with the general permit for operation of the vehicle ABE). In trade, especially for Mercedes has agreed sets of elements to suppress interference with the installation instructions. Agree radio with antenna. To do this, set the low-power medium wave transmitter is approximately 1400 kHz. If there is a transmitter that can be used to adjust the noise generator. Turn the screw with a small screwdriver antenna matching (front left in the housing the radio) until until you reach the best possible reception, or the maximum level of noise.
A warning At the same time, turn the adjustment screw a maximum of only 1/2 turn.
| 
