printable version

Rubber wiper blades

Rubber wiper blades should be replaced with poor quality glass cleaner. The trade offered as a complete wiper blade (rubber brush holder), and separate the rubber wiper. If you are replacing only the rubber brush, pay attention to the fact that it was not bent holder.

A rubber brush is introduced into the two metal retaining rails (1), which should be handled when removed separately.

Withdrawal

When working on the wipers Remove the ignition key. Moving the lever brush or wiper linkage, starting from the position "1" of the ignition key may engage automatic return to the starting position of brushes. E. Wiper operates in an idle mode as long as it is in the rest position. There is a risk of injury!

PERFORMANCE ORDER

1. Lift the lever of the wiper blade, not fixing it. 2. Press down the plastic clip on the corrugated part (1) and slide the wiper blade downwards (2) to the hook on the lever of the wiper blade. 3. narrow screwdriver (2) move from the closed side of the rubber brush back from two steel rails (2), and gently pull the brush out of the rubber tracks. 4. Unhook the rubber brush (3) of the clamps (4) on the blade.

Setting

PERFORMANCE ORDER

1. Available Lay rubber brush is not fixing rails and clips wiper. 2. Both the open profile side rails type in rubber brush so that the guide grooves looked toward Tyre and lock in the groove. Bending the guide is to look in the direction of the glass. 3. The spring latch is easier to enter the lock groove, if the pre-front end of it mowed file and lubricated with soapy water (detergent). 4. Lubricate the rubber brush on the closed side, soapy water, it is better to slide in the clamp. 5. The two steel rails and rubber brush clamp pliers and hook in the clips of the wiper. 6. The wiper blade must be mounted so that it is between the two guide pins on the wiper arm. A warning If the new wiper blade, push down the plastic clips on the splines. 7. Push the wiper blade hooks her arm, hold the plastic clamps and thereby lock the wiper blade. 8. Push the wiper lever. At the same time, pay attention to the fact that the rubber brush everywhere adjacent to the glass. 9. Turn the wiper. Purging sector must be easy to clean. A warning Sponge Rubber wiper blade when the direction of movement should be bent (overturn). If not, gently bend the arm of the wiper blade so that it is parallel to the end of the glass.