 printable version
Accumulator battery
The battery is located on the right side under the boot floor.
A warning  Some commercially installed car radios are coding. Anti-theft coding prevents incompetent commissioning of the unit, if the electrical supply system is interrupted. Electrical supply system, for example, interrupted by disconnecting the wires from the battery terminals when removing the radio, or if the fuse blows radio. If the radio is coded, before disconnecting the wires from the battery terminals fix the radio code. If the code is not known, the only shop from Mercedes can be put into operation again, the car radio.
| 1. Bolts
2. Holder
3. Terminal negative pole
4. The positive pole terminal | 5. Turboprovod to divert the gases released
6. The protective cover of the positive pole
G1. Accumulator battery |
Withdrawal | PERFORMANCE ORDER | | 1. Do not insert the ignition key. | | 2. Disconnect the battery, first line (3) connecting the pole of the battery (-) to the body of the car, then the positive cable (4) (+) for this lift up the cover (6). | | 3. Remove the battery line (5) for removing gases evolved. | | 4. Unscrew and remove the screws (1) to the mounting plate (2) on the basis of the battery. In the battery at 100 Ah, there is only one bolt. | 5. Remove the battery.
A warning Batteries contain harmful substances that should not fall into the trash. When buying a new battery old return to the seller or hand over items on the storage of special waste.
|
|
Setting | PERFORMANCE ORDER | | 1. Before installing the clean polished pole of the battery, it is suitable for brass wire brush. To prevent corrosion of both poles cover antacid grease. | | 2. Install the battery, planted it on the mounting plate and screw tight. | | 3. Slide the battery to the pipeline for discharging released gases. | 4. Connect to the terminals of the positive lead to the positive terminal (+) then the negative (cabinet) wire to the negative pole.
A warning Wires connect the battery only when the ignition is switched off, otherwise it may be damaged by the control device of the fuel injection. Due to improper connection of the battery can be considerable damage to the generator and the electrical system. Pay attention to the impeccable connection to the car body and clean contacts. High contact resistance of contacts leads, especially at start-up, overload electronic control devices and can in extreme cases lead to their failure.
| | 5. Close the cover at the positive pole and fix it. | | 6. Set the time on the clock. | | 7. Enter the anti-theft code for the radio (see. Subsection 1.14.16.). |
|
|
