printable version
Rear brake disc
Withdrawal
PERFORMANCE ORDER | 1. Remove the caliper of the rear wheel and hang a homemade wire hooks to the brake hose did not break traction. A warning Do not disconnect the hose, otherwise you'll have to remove the air from the brake system.
| | 2. Remove the wrench from the Allen bolt (64) and remove the brake disc (62) with the rear axle shaft flange (68), (70), dowel pin. | A warning The parking brake must be fully released. Hard Disc separate sitting light plastic mallet.
|
|
Setting PERFORMANCE ORDER | 1. In order to provide uniform braking on both sides, both rotors must have the same ground surface and a uniform depth of asperities thereon. Check brake disc thickness and lateral runout. | 2. If there is rust on the flange of the brake disc and rear axle shaft, remove it. Cover the planting of the rear axle shaft flange of a thin layer of high-temperature lubricant, for example, Molykote-Paste "U", Molykote-Paste G Rapid, Liqui-Moly-Paste 36. | 3. Clean the new brake disc from the protective lacquer Universal Nitro Thinner. Instead, you can also clean and degrease the brake discs a jet of high pressure steam. | 4. If you installed the old brake disc and clean and visually inspect the surface of the friction pads for parking brake. Check the mobility of the spacer lock brake pads handbrake. | 5. So, install the brake disc on the rear axle shaft flange to an adjusting pin entered the brake disc. Screw a new bolt and tighten to a torque of 10 Nm | 6. Install the caliper. |
|
|